We present a combined electrical and modeling study to determine the tunneling electron effective mass and electron affinity for HfO2. Experimental capacitance-voltage (C-V) and current-voltage (I-V) characteristics are presented for HfO2 films deposited on Si(100) substrates by atomic layer deposition (ALD) and by electron beam evaporation (e-beam), with equivalent oxide thicknesses in the ran...

Charge transport in organic devices depends strongly on the molecular order and morphology of the organic semiconductor thin films. In the design of new organic semiconductors, the selection of the appropriate core plays a key role in the molecular packing and charge transport characteristics of the organic device. Four derivatives of carbazole that mainly differ in the extension of the π-conju...

Abstract: Different thickness of Cu2S thin films were prepared by vacuum evaporation under a pressure of 10-6 torr at an evaporation rate of 3Å /sec. Cu2S has direct band gap energy and indirect band gap energy at 1.2eV and 1.8 eV respectively. This paper presents the analysis of structural and optical properties of the Cu2S thin film by X-ray diffractometer (XRD) and UV-Vis-NIR Spectrophotomet...

We report on the tuning of the Kondo effect in thin Au films containing a monolayer of cobalt(II) terpyridine complexes by altering the ligand structure around the Co(2+) ions by depositing a thin Au capping layer on top of the monolayer on Au by magnetron sputtering (more energetic) and e-beam evaporation (softer). We show that the Kondo effect is slightly enhanced with respect to that of the ...

the ac electrical behaviour of nano porous silicon (psi) with tio2 thin films was examined over the range of frequency 102 to 105 hz. porous silicon (psi) layers were obtained by electrochemical etching in hf solution and tio2 thin films were deposited on psi substrates by using electron beam evaporation technique at room temperature. the porosity of psi layer was found by using the gravimetric...

A technique for the study of evaporation from the precorneal and cornea! surfaces has been developed. Evaporation from the superficial lipid layer (SLL) has been measured to be 10.1 x 10~ Gm.cm.^secr When this lipid layer is removed, evaporation increases around fourfold. Evaporation from the dry epithelial surface occurs at a rate of 1.8 x JO" Gm.cmr^secr After the epithelium is removed, a twe...

this paper presents mathematical models of thin layer forced convection solar drying of cuminum cyminum using two drying methods (mixed and indirect) at different operating conditions. the average initial moisture content of the seeds for all tests was about 43% d.b. and the drying was performed continuously, in each test, for a uniform period of 90 minutes drying time in a solar cabinet dryer ...

Reducing absorber layer thickness below 500 nm in regular Cu(In,Ga)Se2 (CIGS) solar cells decreases cell efficiency considerably, as both short-circuit current and open-circuit voltage are reduced because of incomplete absorption and high Mo/CIGS rear interface recombination. In this work, an innovative rear cell design is developed to avoid both effects: a highly reflective rear surface passiv...

We describe a microfluidic platform to screen for salt forms of pharmaceutical compounds (PCs) via controlled evaporation. The platform enables on-chip combinatorial mixing of PC and salt former solutions in a 24-well array (~200 nL/well), which is a drastic reduction in the amount of PC needed per condition screened compared to traditional screening approaches that require ~100 μL/well. The re...

By using a coupled land surface-atmosphere model with initial conditions of varying resolution and ensembles of systematically changed soil moisture, convective-scale simulations of a typical frontal rainstorm in the Yangtze River Basin are collected to investigate: (1) effects of different datasets on the simulated frontal mesoscale convective systems (MCSs); (2) possible linkages between soil...