introduction: in the present research, the effect of morphine consumption during pregnancy on the development of the embryo’s spinal cord was studied in wistar rat. methods: female wistar rats (wt: 250-300 g) were mated with males. the test group received morphine (0.01 mg/ml) in their drinking water. pregnant rats were later killed with chloroform on the 12th, 13th and 14th days of pregnancy, ...

Neutron reflectivity measurements were performed on a cell membrane mimic system consisting of a polyelectrolyte multilayer plus a synthetic terpolymer plus a phospholipid layer, at all of the intermediate steps in the assembly of the composite, to obtain neutron scattering length density depth profiles. The polyelectrolyte multilayer functions as a soft, water-containing cushion for the membra...

In this paper, Vacuum Assisted Resin Transfer Molding (VARTM) method was simulated by analytical solution. Then the effect of parameters like fiber density, distribution of layer thickness, perform layer thickness, resin viscosity was investigated theoretically. Obtained results show that by selecting optimum distribution layer thickness, increasing fiber volume fraction, reducing viscosity of ...

Moisture absorption in model photoresist films of poly(4-hydroxystryene) (PHOSt) and poly(tert-butoxycarboxystyrene) (PBOCSt) supported on silicon wafers was measured by X-ray and neutron reflectivity. The overall thickness change in the films upon moisture exposure was found to be dependent upon the initial film thickness. As the film becomes thinner, the swelling is enhanced. The enhanced swe...

This study evaluated the dosimetric impact of surface dose reduction due to the loss of backscatter from the bone interface in kilovoltage (kV) X-ray radiation therapy. Monte Carlo simulation was carried out using the EGSnrc code. An inhomogeneous phantom containing a thin water layer (0.5-5 mm) on top of a bone (thickness = 1 cm) was irradiated by a clinical 105 kVp photon beam produced by a G...

In this study, the torsional stability analysis is presented for thin cylindrical with the functionally graded (FG) middle layer resting on the Winker elastic foundation. The mechanical properties of functionally graded material (FGM) are assumed to be graded in the thickness direction according to a simple power law and exponential distributions in terms of volume fractions of the constituents...

This paper researches two key factors (angle and thickness) of a weak layer in relation to their influencing mechanism on slope stability. It puts forward the sliding surface angle and morphological model criteria for the control of rock slopes and realization of its failure mechanism. By comparing the Failure Modes and Safety Factors (Fs) obtained from numerical analysis, the influence pattern...

seismic refraction and downhole survey were employed to study dynamic characteristics of subsurface materials in bam city, southeast of iran. the data acquisition was performed at 160 p and s-wave refraction stations and 15 boreholes in the city. to derive velocity depth sections along these profiles as well as to perform downhole diagrams, seisimager software was used. based on the obtained va...

In this research, modification on the ultrafiltration (UF) membrane by synthesis of a thin layer of polyamide selective layer was designed for high performances of forward osmosis (FO) water treatment. Two monomers, m-Phenylenediamine (MPD) and Trimesoyl chloride (TMC) with different concentrations of MPD (2.0% w/v and 1.0% w/v) were reacted with TMC (0.15% w/v) for interfacial polymerization (...

in this paper, homotopy perturbation method (hpm) has been applied to investigate the effect of magnetic field on cu-water nanofluid flow in non-parallel walls. the validity of hpm solutions were verified by comparing with numerical results obtained using a fourth order runge–kutta method. effects of active parameters on flow have been presented graphically. the results show that velocity in bo...