The difficulty in measuring load temperatures inside reheating gas furnaces may be circumvented by appropriate use of on-line numerical models. In this article we describe a model of pusher furnaces, used to reheat steel slabs. The model uses thermocouple measurements at fixed positions inside the furnace to calculate the temperature of the combustion products, and takes into account radiative ...

The blast-furnace process consists of a large number of processes that are physicochemical, thermal and mechanical interconnected processes. In addition to main processes consisting of iron oxides reduction, pig iron and slag melt creation, also realised are fuel combustion, gas flow, charge and melt flow, dissociation and other reactions in the solid and liquid phases. Inputs to the blast-furn...

This work evaluates the suitability of iron aluminide coatings for use in high temperature fossil fuel combustion environments, such as boiler applications. The coatings are applied using High Velocity Oxy-Fuel (HVOF) thermal spray techniques. Bulk Fe3Al coatings are known to exhibit excellent oxidation and sulfidation resistance at high temperatures, however, the behavior of HVOF-deposited Fe3...

The thermal expansivity of oceanic lithosphere is a key mineral physics parameter that controls the rate of seafloor subsidence. Because of strongly temperature-dependent mantle rheology, effective expansivity for lithosphere as a whole could be substantially lower than indicated by mineral physics data. Viscoelastic modeling indicates that this reduction in expansivity could be as high as ∼15–...

The research reported herein studied the permeability of concrete containing recycled-concrete aggregate (RA), superfine phosphorous slag (PHS), and ground granulated blast-furnace slag (GGBS) with and without stress. Test results showed that the chloride diffusion coefficient of RA concrete (RAC) without external loads decreased with time, and the permeability of RAC is much lower than that of...

Upconversion luminescence imaging of thermal barrier coatings (TBCs) has been shown to successfully monitor TBC delamination progression during interrupted furnace cycling. However, furnace cycling does not adequately model engine conditions where TBC-coated components are subjected to significant heat fluxes that produce through-thickness temperature gradients that may alter both the rate and ...

Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...

Thermal cracking of kerogens and bitumens is widely accepted as the major source of natural gas (thermal gas). Decomposition is believed to occur at high temperatures, between 100 and 200 degrees C in the subsurface and generally above 300 degrees C in the laboratory. Although there are examples of gas deposits possibly generated at lower temperatures, and reports of gas generation over long pe...