A modeling procedure is developed for natural convection heat transfer from an isothermal heated sphere located at the center of an isothermal, cooled, sphericalshaped enclosure. The model is based on the linear superposition of conduction and convection solutions, where the convective component is determined based on a combination of two limiting cases, laminar boundary layer convection and tr...

the purpose of this paper is to investigate the egm method and the behavior of a solid particle suspended in a twodimensional rectangular cavity due to conjugate natural convection. a thermal lattice boltzmann bgk model is implemented to simulate the two dimensional natural convection and the particle phase was modeled using the lagrangian–lagrangian approach where the solid particles are treat...

Nonlinear thermal convection in a spherical fluid layer in the presence of spherically symmetric gravity, spherical RayleighBénard convection, is investigated. At the onset of spherical Rayleigh-Bénard convection, there exists the (2l+1)-fold degeneracy of the linear solution, where l is the degree of a spherical harmonics. Nonlinear convection is studied through fully three-dimensional numeric...

The interaction of thermal radiation with conduction and laminar natural convection in a vertical circular pin, situated at participating gas, is numerically investigated. An absorbing and emitting gas is considered, and treated to be a gray participating media. Under the idealizing of gray gas, the Rosselan4 approximation is employed to describe the radiative heat flux in the energy equation. ...

a lattice boltzmann method is applied to demonstrate the comparison results of simulating natural convection in an open end cavity using different hydrodynamic and thermal boundary conditions. the prandtl number in the present simulation is 0.71, rayleigh numbers are 104,105 and 106 and viscosities are selected 0.02 and 0.05. on-grid bounce-back method with first-order accuracy and non-slip met...

as it rises in b to enter c above the midline, etc. It can be easily seen that a similar oscillation about the midline takes place in the rotating fluid annulus of Figure 4a and in the more general situation of Figure 4b. These oscillations can be made quite small by adjusting the density of the buffer to match the particle density and by speeding up the rate of buffer flow to shorten the perio...

The interaction of thermal radiation with conduction and laminar natural convection in a vertical circular pin, situated at participating gas, is numerically investigated. An absorbing and emitting gas is considered, and treated to be a gray participating media. Under the idealizing of gray gas, the Rosselan4 approximation is employed to describe the radiative heat flux in the energy equation. ...

This study discusses the application of Taguchi method in assessing minimum entropy generation and maximum heat transfer rate for natural convection in an enclosure embedded with isothermal cylinder. The simulations were planned based on Taguchi’s L25 orthogonal array with each trial performed under different conditions of position and aspect ratio (AR) of the cylinder. The thermal lattice Bolt...

Heat transfer of magnetothermal convection with the presence or absence of the magnetic force acting on the susceptibility gradient (fsc) was examined by three-dimensional numerical computations. Thermal convection of water enclosed in a shallow cylindrical vessel (diameter over vessel height = 6.0) with the Rayleigh-Benard model was adopted as the model, under the conditions of Prandtl number ...

a numerical investigation of forced convection in a channel with hot solid block inside a square porous block mounted on a bottom wall was carried out. the lattice boltzmann method was applied for numerical simulations. the fluid flow in the porous media was simulated by brinkman-forchheimer model. the effects of parameters such as porosity and thermal conductivity ratio over flow pattern and t...