In this paper, novel small-signal averaged models for DC-DC converters operating at variable switching frequency are derived. This is achieved by separately considering the ontime and the off-time of the switching period. The derivation is shown in detail for a synchronous Buck converter and the model for a Boost converter is also presented. The model for the Buck converter is then used for the...

In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low v...

1 This work is supported by Philips Research, Briarcliff Manor, NY, through Colorado Power Electronics Center Abstract – Single-switch step-up/step-down converters, such as the buck-boost, SEPIC and Cuk, have relatively high voltage and current stresses on components compared to the buck or the boost converter. A buck-boost converter with two independently controlled switches can work as a boos...

– A buck converter controlled by naturally-sampled constant frequency pulsewidth modulation in continuous mode of operation is analysed. For a fixed set of converter parameters and varying the dc supply voltage only the buck converter can be driven into chaos through a process of period doublings. A good agreement between simulation and experiments is obtained. Key-words: buck converter , ident...

In this paper, a robust sliding mode controller for the control of dc-dc buck converter is designed and analyzed. Dynamic equations describing the buck converter are derived and sliding mode controller is designed. A two-loop control is employed for a buck converter. The robustness of the sliding mode controlled buck converter system is tested for step load changes and input voltage variations....

This paper present a pulse width modulation non-isolated buck converter using PID controller. The buck converter constituted by one Gto, one inductor, one capacitor, one diode and one load resistor. In this the buck converter connected to the PID controller, PID controller calculate an error value as the difference between a measured process variable and a desired set point. The proportional P ...

In this paper presents new topologies Multilevel DC-DC buck-boost converter which consists of an inductor based boost circuit and a switched capacitor circuit has high voltage gain and flexible output voltage. Operation of these switching devices causes inherently nonlinear characteristic to the DC-DC Converters include buck-boost converter. It is suitable for a low voltage power source such as...

The paper describes the design, simulation and practical implementation of a PV system specifically designed for battery charging applications. A DC-DC synchronous Buck converter is digitally controlled by a dsPIC33F to extract the maximum power from the PV panel and feed it to the battery, according to the data received through the sensors. The system proves to be stable to rapid weather chang...

A discrete controller is designed for high efficiency double frequency buck converter. This double frequency buck converter is comprised of two buck cells: one works at high frequency, and another works at low frequency. It operates in a way that current in the high frequency switch is diverted through the low frequency switch. Thus, the converter can operate at very high frequency without addi...

In this paper fractional order averaged model for DC/DC Buck converter in continues condition mode (CCM) operation is established. DC/DC Buck converter is one of the main components in the wind turbine system which is used in this research. Due to some practical restriction there weren’t exist input voltage and duty cycle of converter therefor whole of the wind system was simulated in Matlab/Si...