Due to the inaccuracy of preset rolling force cold rolling, there is a severe thickness defect in strip head after due flying gauge change (FGC), which affects yield strip. This paper establishes model (RFPM) by combining optimization (RFOM) and deviation prediction (RFDPM). The RFOM used genetic algorithm (GA) optimize deformation resistance friction coefficient models. RFDPM constructed using...

Mathematical model of rolling process is used at cold mill rolling on tandem mills in metallurgy. The model goal is to analyse rolling process according to process data measured on the mill and get immeasurable variables necessary for rolling control and optimal mill pre-set for next rolled coil. The values obtained by model are used as references for superimposed technology controllers (thickn...

In multi-stand cold rolling mills an accurate synchronization of the mill drives is necessary for a good product quality and for a safe process operation. During the standard commissioning procedure the control performance of each drive is optimized individually. However, in normal operation mode the performance is then not always optimal due to the coupling of the drives by the strip being rol...

Shape is an important quality index of cold rolling strip. Up to now, many problems in the shape control domain have not been solved satisfactorily, and a review on the research progress in the shape control domain can help to seek new breakthrough directions. In the past 10 years, researches and applications of shape control models, shape control means, shape detection technology, and shape co...

ISSN 2277 – 5056 | © 2012 Bonfring Abstract--A FEM simulation study was carried out to investigate the influence of the rolling parameters on the rolling process. Using commercial FEM software, ABAQUS, a number of cases were studied. In this paper, a twodimensional Elastic-plastic finite element model to simulate the cold rolling of thick strip with different roll angular velocity and roll diam...

The twin-roll strip casting process is a typical steel-strip production method which combines continuous casting and hot rolling process. The production line from molten liquid steel to the final steel-strip is shortened and the production cost is reduced significantly compared to the conventional continuous casting. The twin-roll strip casting process can produce 1-5 mm thin steel strip direct...

the forging model for cold rolling is one of rolling models that is used in rolling calculations. in this model,the final rolling pressure is an average value and it is not an accurate model.also by using this model,the firction hill curves are plotted due to the central point of the rolling bite length while frictional stresses intersect at the neutral point.in this study, a new model based on...