This research effort focuses on the evaluation of existing design standards for cold-formed steel stud walls and the development of retrofit wall systems. Full-scale wall systems are tested under uniform static pressure using a vacuum chamber. The resistance functions obtained are used to model the dynamic behavior of the walls and to predict performance under blast conditions. This paper focus...

The temperature field analysis method of steel tube reinforced columns under fire by finite element analysis software ABAQUS is proposed in this paper. The theoretical method is validated by tests, and the calculated results agree well with those of tests. On the basis of that, the influencing laws of temperature rising time; section perimeter; steel reinforcement ratio and sectional core area ...

The initial material cost of structural stainless steel is about four times that of structural carbon steel, due largely to the expense of the alloying elements and the relatively low volume of production. Given broadly similar structural performance, additional areas of benefit need to be identified and exploited in order to establish stainless steel as a viable alternative material for constr...

Steel factor, the protein product of the Steel locus in the mouse, is a multifunctional signal for the primordial germ cell population. We have shown previously that its expression accompanies the germ cells during migration to the gonads, forming a "travelling niche" that controls their survival, motility, and proliferation. Here we show that these functions are distributed between the alterna...

The present work has as main aim to make a small introduction about the types of steels, specially the ones used in the construction industry. This material is appreciated in construction due to its many advantages as strengths, resistance, adaptability and flexibility in design, durability, recyclability,...; even thou its also has week points like a low resistance to fire, weak against corros...

The twin-roll strip casting process is a typical steel-strip production method which combines continuous casting and hot rolling process. The production line from molten liquid steel to the final steel-strip is shortened and the production cost is reduced significantly compared to the conventional continuous casting. The twin-roll strip casting process can produce 1-5 mm thin steel strip direct...

Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...

Rubber-steel-layered structures are used in many engineering applications. Laminated rubber-steel bearing, as a type of seismic isolation device, is one of the most important applications of the rubber-steel-layered structures. Interfacial debonding in rubber-steel-layered structures is a typical failure mode, which can severely reduce their load-bearing capacity. In this paper, the authors dev...

Steel plate shear walls (SPSWs) in buildings are known to be an effective means for resisting lateral forces. By using un-stiffened walls and allowing them to buckle, their energy absorption capacity will increase significantly due to the postbuckling capacity. The post-buckling tension field action of SPSWs can provide substantial strength, stiffness and ductility. This paper presents the Fini...

A 0.4C-2Si-1Cr-1Mo steel with an ultrafine elongated grain (UFEG) structure and an ultrafine equiaxed grain (UFG) structure was fabricated by multipass caliber rolling at 773 K and subsequent annealing at 973 K. A static three-point bending test was conducted at ambient temperature and at 77 K. The strength-toughness balance of the developed steels was markedly better than that of conventionall...