One of the most important issues in the plant layout design especially in mass production organizations with high inter-plant logistics is‘material flow and inter-plant traffic analysis and its effects on the production capabilities or pauses in production lines. In this paper the inter-plant traffic analysis issue on the basis of single channel queue model (M/M/1) is analyzed in a carmaker c...

Mini-channel (D = 2.54 mm) and micro-channel (D = 510 pm) heat sinks with a 1-cm heated surface were tested for their high heat flux performance with flow boiling ofR-113. Experimental results yielded CHF values in excess of 200 W cm~ for flow rates less than 95 ml min~ (0.025 gpm) over a range of inlet subcooling from 10 to 32° C. Heat diffusion within the heat sink was analyzed to ascertain t...

steam reforming integrated with oxidation of methanol was considered with numerical simulation. the parallel micro-channels with circular cross sections were used. because when the catalytic deposited inside the rectangular micro-channels, it fills up the edges. hence, the approximation of a cylindrical channel is appropriate. effect of this changing in cross section was considered and results ...

ion channels are naturally occurring pores through the proteins that regulate the passage of ions and thus maintain the concentration of ions inside and outside the cell. the ion channels control many physiological functions and they can show selectivity for a specific ion. ion channels are mostly observed in nerve cells and muscle cells. the influx of ions into cells can be regulated by a gate...

In this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. In numerical study, single and two-phase models have been used. In single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. Effects of volume fraction a...

1.1 INTRODUCTION There now exist several large teletraac data sets exhibiting non-standard features incompatible with classical assumtions of short range dependence and rapidly decreasing tails. For instance, it is worth exploring the variety of data catalogued at the ITA web site www.acm.org/sigcomm/ITA/. These data sets exhibit the phenomena of heavy-tailed marginal distributions and long ran...

This paper explores the subcooled nucleate boiling and critical heat flux (CHF) characteristics of a hybrid cooling module that combines the cooling attributes of micro-channel flow and jet impingement. A test module was constructed and tested using HFE-7100 as working fluid. Increasing the coolant’s flow rate and/or subcooling shifted both the onset of boiling (ONB) and CHF to higher heat flux...

Transient phase change through a horizontal channel that subjected to discrete heat flux and filled with porous media of high-conductivity material, copper, is numerically investigated with n-pentane as the working fluid. The thermal non-equilibrium model is used in conjugate with the multiphase mixture model to analyze the transient behavior of fluid and solid phases. Three cases are studied r...

Transient phase change through a horizontal channel that subjected to discrete heat flux and filled with porous media of high-conductivity material, copper, is numerically investigated with n-pentane as the working fluid. The thermal non-equilibrium model is used in conjugate with the multiphase mixture model to analyze the transient behavior of fluid and solid phases. Three cases are studied r...