In this paper, a new structure for buck-boost Z-source converter based on Z-H topology is proposed. The proposed converter consists of two LC networks similar to the conventional Z-source and Z-H converters. One of the characteristics of the proposed structure is that, without any changing in its’ power circuit, it can be used in different conversions such as dc/dc, dc/ac and ac/ac. This unique...

A full-order dynamic model of the pulse-width modulation (PWM) DC-to-DC SEPIC converter in discontinuous conduction mode (DCM) is presented in this paper. The derivation procedure is based on the smallsignal PWM switch model in DCM used in conjunction with a PWM derived SEPIC topology. The small-signal characteristics of the PWM SEPIC converter in DCM obtained in a similar way as the small-sign...

This thesis presents the theory, design, layout and a proposal for measurement set up of a synchronous DC-DC buck converter. This converter will be used as the supply modulator of power amplifier of mobile phones. The design is done using 45nm CMOS technology. Pmos and nmos switches are synchronously turns on and off for DC voltage conversion. Second order LC type filter is used to filter out t...

The proposed system is to utilize the renewable resources by digital PWM control of synchronous converter. Usually PWM pulse is being generated through a digital system such as microcontroller or Digital signal controller. In stand – alone application these controllers increases the cost but XILINX FPGA based PWM generation reduces the cost. XILINX FPGA is invented by XILINX which is being cons...

This paper presents a modified nine switch inverter with two inputs and two Z-source networks. This inverter has two DC inputs and two AC outputs. Input DC voltages can be boosted to the required level. Amplitude, frequency and phase of AC output voltages can be controlled, independently. The proposed converter can be used in applications with two unregulated DC sources, which require feeding ...

The aim of this paper is presentation of an approach for modeling , control and optimization of a photovoltaic pumping system which contains a PV generator , DC-DC boost converter, MPPT controller, DC-AC inverter and a BLDC motor. We use an intelligent control method for searching the maximum power point (MPP). This method uses a fuzzy logic controller applied to a drive a DC–DC converter to an...

For the past two decades, Brushless DC motor has become more efficient and robust motor in industrial applications due to their simplicity in structure, reliability, good mechanical properties. The absence of brushes features these motors similar to AC motors whereas their speed performance is nearly equal to that of the DC motors. Thus the combined advantages of AC and DC motors make these mot...

Three discontinuous operating modes of PWM converters are considered in this paper-the discontinuous inductor current mode (DICM), the discontinuous capacitor voltage mode (DCVM) and a previously unidentified mode named discontinuous quasi-resonant mode (DQRM). DC and smallsignal ac analyses are applicable to all basic PWM converter topologies. Any particular topology is taken into account via ...

Renewable energy sources (RES) place main role in present days to generate power. The Switched Boost Inverter is a single stage dc-ac power converter, whose output voltage can be either greater or less than its input dc voltage. This converter can supply both dc and ac loads, simultaneously, which makes it suitable for micro grid applications. Also, this converter allows shoot-through of the in...

The development of a Solid State Transformer (SST) that incorporates a DC-DC multiport converter to combine both photovoltaic (PV) power generation and battery energy storage. The DC-DC stage is based on a quad active-bridge (QAB) converter which not merely provides isolation for the load, but also for the PV and storage. The AC-DC stage is implemented with a pulse-width-modulated (PWM) single ...