A study of the ignition of non-fire-resistant hydraulic fluid sprays was conducted by the National Institute for Occupational Safety and Health. Both an open flame and a hot steel surface were used as the external heat sources. With the open flame as the heat source, the minimum oil temperature and minimum spray nozzle pressure that resulted in an ignition were measured. The effects of the dist...

A pilot model of the hypersonic rarefied wind-tunnel (HRWT) has been developed and its flow characteristics have been measured. The HRWT consists of a gas heater which produces an increase in working gas temperature, an expansion nozzle with a large expansion ratio, a vacuum chamber as the test section, and an evacuation system with high exhaust velocity to allow a continuous operation at low a...

In the present work we identified and quantified the effect of hydrodynamic stress on two different microalgae strains, Dunaliella tertiolecta and D. salina, cultivated in bench-scale bubble columns. The cell death rate constant increased with increasing gas-entrance velocity at the sparger. Dunaliella salina was slightly more sensitive than D. tertiolecta. The critical gas-entrance velocities ...

A simple and novel method--in the form of solution spraying--was developed to fabricate biodegradable, porous poly(L-lactic acid) (PLLA) particulates for scaffold. PLLA pellets were dissolved in an organic solvent. Then, 5 % PLLA-dioxane solution was sprayed using an air-assisted atomizer with a nozzle diameter of 2.5 mm at an air flow rate of 15 L/min. After the sprayed solution solidified in ...

We describe a method to fabricate tapered glass nozzles suitable for liquid-jet-target generation in laser-plasma soft x-ray and extreme ultraviolet sources. In the method, a tapered nozzle is formed as an integral part of a flexible capillary glass tubing. The method makes use of inert materials, extending the possible choice of target liquids compared to current nozzles. It also provides flex...

The attention of the present paper is focused on the intensive heat removal with arrays of impinging jets. Three jet configurations are tested which involve variation of geometric parameters such as nozzle shape, diameter and nozzle-tonozzle spacing and impingement distance and of flow rate. The convective heat transfer coefficient is measured with infrared thermography applied to the heatedthi...

This study demonstrates that the hydrodynamic phenomena taking place inside the capillary limits the frequency range of voltage pulses for stable single event electrospraying SEE , when the meniscus/cone size is defined by the inner diameter of the nozzle. For the analysis of SEE, we used a one-dimensional model describing the displacement and oscillations of the liquid inside the nozzle. The f...

1) Hydraulic Analysis of the Emergency Core Spray System in a BWR The emergency spray system of a BWR delivers cold water to the core after a large-break loss of coolant accident has emptied the reactor vessel. The system comprises a large water pool, a pump, a spray nozzle and connecting pipes (Figure 1). All pipes are smooth round tubes made of stainless steel with 10 cm internal diameter. Th...

Near-field vector intensity measurements have been made of a 12.7-cm diameter nozzle solid rocket motor. The measurements utilized a test rig comprised of four probes each with four low-sensitivity 6.35-mm pressure microphones in a tetrahedral arrangement. Measurements were made with the rig at nine positions (36 probe locations) within six nozzle diameters of the plume shear layer. Overall lev...