In the present work, different concentrations of Cu ion (1, 2, 5 and 10 wt %) were doped in the TiO2 film by a sol-gel method and dip coating process. The morphology of the Cu-doped TiO2 films were characterized by scanning electron microscopy (SEM) and the results showed that the doped Cu made no change to the TiO2 films. The nitric oxide (NO) release experiment showed that these Cu-doped surf...

Nitrogen-doped TiO2 (N-TiO2) nanoparticles were prepared by calcining the anatase TiO2 nanoparticles under ammonia atmosphere. The N-TiO2 showed higher absorbance in the visible region than the pure TiO2. The cytotoxicity and visible-light-induced phototoxicity of the pure- and N-TiO2 were examined for three types of cancer cell lines. No significant cytotoxicity was detected. However, the visi...

We report the synthesis of nitrogen-doped urchin-like rutile TiO2 nanostructure at room temperature without further heat treatment. The process was operated through hydrolysis of Ti(OC4H9)4 employing the direct amination of the product. The samples characterized by x-ray diffraction (XRD), scanning electron microscopy (SEM), Transmission electron microscopy (TEM), Raman spectroscopy and Brunaue...

At this work we synthesized electrospun titanium oxide (TiO2) and nitrogen-doped (N-doped TiO2) for producing hydrogen (H2) in the same time pollutant removal from waste water by photocatalytic oxidation at room contitions.We use isopropoxide (TiP)/polyvinylpyrrolidone (PVP) solution to prepare dispersed polymer nanofibers sol–gel processing electrospinning techniques. TiO2 is a very effective ...

Gas-phase photocatalysis using titanium dioxide (TiO2) has been regarded as an attractive technology for the control of VOC emissions. However, TiO2 requires ultraviolet irradiation exceeding the bandgap energy of 3.0 eV (wavelength < 400 nm), hence effectively eliminating the utilization of solar and interior lighting as a source of photo-activation energy. Recently, a number of studies have d...

TiO2 supports doped with different amounts of Si were prepared by a sol-gel method, and 1 wt% vanadia (V2O5) loaded on Si-doped TiO2 was obtained by an impregnation method. The mole ratio of Si/Ti was 0.2, NOx conversion exceeds 94% at 300 degrees C and GHSV of 41,324 hr(-1), which is about 20% higher than pure V2O5/TiO2. The catalysts were characterized by XRD, BET, TEM, FT-IR, NH3-TPD, XPS, H...

A novel photoelectrochemical (PEC) biosensor was fabricated based on N-doped TiO2 for the detection of Hg(2+) through the quenching of photogenerated electrons. The N-doped TiO2 was synthesized by a sol-gel method with urea and tetrabutyl titanate as the N and Ti sources. Compared with the undoped TiO2, the N-doped TiO2 showed an enhanced photocurrent response under visible light (λ > 420 nm). ...

H2S reduction over Pure and Sulphur doped TiO2 nanoparticles was studied in this work. The parameter was catalytic destruction of H2S gas under high temperature of 450C using fixed bed catalytic system under laboratory conditions. Under these conditions 99.97% reduction was achieved using S-doped TiO2. 2.89% Sulphur was adsorbed on S-doped TiO2 nanoparticles to form Ti(SO4)2. Comparatively, no ...

Zr/N co-doped TiO2 nanostructures were successfully synthesized using nanotubular titanic acid (NTA) as precursors by a facile wet chemical route and subsequent calcination. These Zr/N-doped TiO2 nanostructures made by NTA precursors show significantly enhanced visible light absorption and much higher photocatalytic performance than the Zr/N-doped P25 TiO2 nanoparticles. Impacts of Zr/N co-dopi...