Notch deformation behaviour under monotonic and cyclic loading conditions was investigated using circumferentially notched round bar and double-notched flat plate geometries, each with two different notch concentration factors. Notch strains for the double-notched plate geometry were measured with the use of miniature strain gauges bonded to specimens made of a vanadium-based microalloyed steel...

An electroplating spring-bridge micro-tensile specimen is fabricated to carry out a series of monotonic tensile testing on it. Freestanding thin films were loaded by performing monotonic loading/unloading and tensiontension fatigue experiments. Loading was applied using a piezoelectric actuator with 0.1 μm resolution connected through pin hole into the test chip specimen. Loads were measured by...

The physical basis of computationally tractable models of crystalline plasticity is reviewed. A statistical mechanical model of dislocation motion through forest dislocations is formulated. Following Franciosi and co-workers, the strength of the short-range obstacles introduced by the forest dislocations is allowed to depend of the mode of interaction. The kinetic equations governing dislocatio...

Hysteresis energy decreased significantly as nanocrystalline NiTi shape memory alloy was under triangular cyclic nanoindentation loadings at high rate. Jagged curves evidenced discrete stress relaxations. With a large recovery state of maximum deformation in each cycle, this behavior concluded in several nucleation sites of phase transformation in stressed bulk. Additionally, the higher initial...

The effects of loading rate on the reinforced concrete beams are experimentally studied in the present paper. Firstly, the effects of strain rate on the different grades of concrete are investigated using the electro-hydraulic servo-controlled testing system at the strain rate that might be experienced during earthquakes. Based on the test results, the dynamic increasing factors (DIF) of concre...

Combined in-phase tension/torsion loading was applied to 8-ply 45° 4 E-glass/epoxy composite shafts under monotonic and fatigue conditions to determine the effects of multi-axial loading on its failure. A damage criterion for multi-axial monotonic loading was proposed considering the contribution of both normal and shear stresses on the plane of failure. The experimental data showed an excellen...

Skin soft tissue (e.g., porcine skin) was tested in vitro under uniaxial cyclic loading, and its biomechanical responses were investigated to realize some basic properties which are very significant in assessing the fatigue life of skin soft tissue. The results show that a cyclic accumulation of peak and valley strain, which can be terminologically called as ratchetting in terms of material sci...