Wire Electrical Discharge Machining (WEDM) is a non-traditional thermo-electric process capable of machining hard materials of highly complex three dimensional shapes. In this paper, the dry WEDM experimentation is conducted using oxygen as a dielectric medium. The deionized water is replaced by the oxygen as a dielectric medium to ameliorate the environmental impact in the machining surroundin...

Micro-electrical discharge machining is an evolution of conventional EDM used for fabricating three-dimensional complex micro-components and microstructures with high precision capabilities. The material removal process has stochastic nature and is still not fully understood. This paper presents experimental results on observing the material removal rate (MRR) in dependence of alternating machi...

Presented is an experimental investigation of the machining characteristics and the effect of wire electrical discharge machine (WEDM) process parameters during machining of Al/ZrO2(p) particulate reinforced metal matrix composite (PRMMC). Experiments are carried out to investigate the effects of input parameters such as dielectric conductivity, pulse width, time between pulses, maximum feed ra...

Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...

Wire-cut electric discharge machining is a nontraditional technique by which the required profile is acquired using sparks energy. Concerning wire-cut electric discharge machining, high cutting rates and precision machining is necessary to improve productivity and achieve high quality of machined workpieces. In this research work, an experimental investigation was introduced to achieve higher p...