The creation of highly oriented, co-extruded polypropylene (PP) tapes allows the production of recyclable ‘‘all-polypropylene’’ (allPP) composites, with a large temperature processing window and a high volume fraction of highly oriented PP (>90%). The wholly thermoplastic nature of these ‘self-reinforced’ composites implies that the mechanical performance may vary with temperature. This paper d...

Previous research on the validity and adverse impact (AI) of predictor composite formation focused on the merits of regression-based or ad hoc composites. We argue for a broader focus. Ad hoc chosen composites are usually not Pareto-optimal, whereas the regression-based composite represents only one element from the total set of Pareto-optimal composites and can, therefore, provide only limited...

The creep behavior of bagasse-based composites with virgin and recycled polyvinyl chloride (B/PVC) and high density polyethylene (B/HDPE) as well as a commercial wood and HDPE composite decking material was investigated. The instantaneous deformation and creep rate of all composites at the same loading level increased at higher temperatures. At a constant load level, B/PVC composites had better...

acrylonitrile butadiene rubber (nbr) composites are prepared from waste nylon 66 short fiber using a two-roll mill mixer. the effects of fiber content and bonding agent on the mechanical and morphological properties of the composites are studied. the curing characteristics of the composites have been studied by using cure rheometer. the cure and scorch time of the composites decrease while cure...

The injectable composites were formulated from melt-derived 45S5 bioactive glass powder and gum tragacanth. The effect of tragacanth concentration (2 and 4 w/v%) and powder to liquid ratio (P/L= 1.5 to 2.5) on rheological properties, injectability, degradation, swelling, and bioactivity the composites was studied. With the increase of P/L ratio and tragacanth concentration, the force requ...

Hydroxyapatite is a biocompatible ceramic and reinforcement for bone implantations. SEVA/HAP composite content HAP filler with difference particle sizes were designed. Mechanical tests like tensile modulus, UTS, strain at break and biodegradation were investigated. Results illustrated much increase tensile modulus of composites content HAP nano powders ratio to micro powders. Also UTS analysis ...

This paper compares the values of the thermal and fire resistance properties of composites made using the hand layup technique. E-Glass fiber reinforced epoxy composites was fabricated by filling varying concentration of aluminum oxide (Al2O3), magnesium hydroxide(Mg(OH)2), silicon carbide (SiC), and hematite powder. The main aim of this work was to determine the thermal conductivity, thermal e...

Clinical trials have identified secondary caries and bulk fracture as the main causes for composite restoration failure. As a measure to avoid frequent reinterventions for restoration replacement, composites with some sort of defense mechanism against biofilm formation and demineralization, as well as materials with lower susceptibility to crack propagation are necessary. Also, the restorative ...

Laminated magnetoelectric composites of Li0.058(Na0.535K0.48)0.942NbO3 (LKNN)/Co0.6Zn0.4Fe1.7Mn0.3O4 (CZFM) prepared by the conventional solid-state sintering method were investigated for their dielectric, magnetic, and magnetoelectric properties. The microstructure of the laminated composites indicates that the LKNN phase and CZFM phase can coexist in the composites. Compared with the particul...

The processing conditions for preparing well dispersed silica-graphene nanoplatelets and silica-graphene oxide nanoplatelets (GONP) composites were optimized using powder and colloidal processing routes. Fully dense silica-GONP composites with up to 2.5 vol% loading were consolidated using spark plasma sintering. The GONP aligned perpendicularly to the applied pressure during sintering. The fra...