Austenitic stainless steel SS304 grade was welded with active Tungsten Inert Gas (TIG) welding process by applying a flux paste made of SiO2 powder and acetone. SiO2 flux application improves the weld bead depth with a simultaneous reduction in weld bead width. The improvement in penetration results from arc constriction and reversal of Marangoni convection. Experimental studies revealed that t...

The effect of repeated repair welding, shielded with argon, on microstructural properties, corrosion resistance, and dry sliding wear behavior of aluminum alloy 5083/H116 were investigated. Samples were welded by metal inert gas welding method. 100% argon was used to protect fusion zone. Aluminum alloy 5356 was used as the filler metal. The samples for microstructure, corrosion, and wear tests ...

Taking into account the technical characteristics of the welding processes, associated with the fulfi lling clients’ requirements, the assurance of safe and healthy working places as well as the environment protection the fundamental meaning belongs to the application of the appropriate methods of risk assessment of these processes. The paper presents the results of risk analysis, using an inte...

Welding of niobium and tantalum materials is currently conducted in vacuum or inert gas chambers, which limits the size of the equipment to be produced. The objective of this study is to investigate the means to make TIG welding on these materials in atmospheric environment and analyse the effect of heat input on the properties of welds. It was found that it is possible to make TIG welds on the...

Conventionally, the quality of the weld is ascertained only after the welding has been completed through the use of NDT techniques. A lot of time, material and manpower is wasted before one comes to know about the soundness of the weld. These limitations can be overcome if the weld is continuously monitored in real time for the assessment of defects using appropriate NDE sensors. This paper hig...

Ultrasonic-assisted tungsten inert gas welding was carried out on a thin plate of 2195 Al-Li alloy, and the characteristics of the weld pores were analyzed in terms of their size and porosity. The effects of welding speed and ultrasonic power on the porosity and size of the pores were investigated. The pores were found to occur primarily adjacent to the surface of the weld. The porosity decreas...

This study evaluated the tensile and flexural strength of tungsten inert gas (TIG) welds in specimens made of commercially pure titanium (CP Ti) compared with laser welds. Sixty cylindrical specimens (2 mm diameter x 55 mm thick) were randomly assigned to 3 groups for each test (n=10): no welding (control), TIG welding (10 V, 36 A, 8 s) and Nd:YAG laser welding (380 V, 8 ms). The specimens were...

Butt joints of A5052 aluminum alloy and SS400 steel, with a new type of chamfered edge, are welded by means of metal inert gas welding and ER4043 Al-Si filler metal. The microhardness and microstructure of the joint are investigated. An intermetallic layer is found on the surface of the welding seam and SS400 steel sheet. The hardness of the intermetallic layer is examined using the Vickers har...