In this article, a toolbox based on a monitoring and control interface (MCI) is presented and applied in a heat exchanger. The MCI was programed in order to realize sensor fault detection and isolation and fault tolerance using virtual sensors. The virtual sensors were designed from model-based high-gain observers. To develop the control task, different kinds of control laws were included in th...

The effect of pulsation on the heat transfer rates, for turbulent water stream with upstream pulsation of different amplitudes, in a double-pipe heat exchanger for both parallel and counter flows, with cold water on the shell side, was investigated. Pulsation frequencies, with using a reciprocating device, ranged up to 260 cycles per minute (up to 4.3 Hz) and 5 different displacement amplitudes...

An investigation on enhancement of heat transfer is carried out for a double pipe exchanger in which the outer wall inner provided with circumferential labyrinth passages. Rectangular and triangular cavities fixed tooth thickness, height, pitch are considered effect added structures characteristics discussed. A two-dimensional steady numerical simulation using ANSYS-FLUENT software. The flow Re...

Common approaches to the simulation of Borehole Heat Exchangers (BHEs) assume heat transfer in circulating fluid and grout to be in a quasi-steady state and ignore fluctuations in fluid temperature due to transport of the fluid around the U-tube loop. Such effects have been shown to have an impact on peak temperatures and hence operation of heat pumps systems when short time scales are consider...

a novel technique is investigated for pid controller adaptation in order to control thetemperature of a liquid-phase reactor tank by using a heat exchanger system. as for nonlinearity,time delay problems and model uncertainties introduced by the heat exchanger, an interval type-2fuzzy system (it2fs) is implemented to enhance and improve the total control performance.moreover, the fuzzy inferenc...