The objective of this research work is to optimize the time of exposure for hot dip galvanizing of mild steel, so as to achieve such a microstructure of zinc coating that protects mild steel for long against atmospheric corrosion. In order to decide the above mentioned parameter the polished samples, one at a time, were dipped in to 500 g molten zinc at 460 to 470 oC in the crucible for a diffe...

Laser forming of steel is a hot forming process with high heating and cooling rate, during which strain hardening, dynamic recrystallization, and phase transformation take place. Numerical models considering strain rate and temperature effects only usually give unsatisfactory results when applied to multiscan laser forming operations. This is mainly due to the inadequate constitutive models emp...

Large diameter steel line pipes are generally produced by cold deforming hot rolled or thermomechanically controlled rolled (TMCR) plate by the three-stage 'UOE' process. Pipe strength has been found to increase or decrease relative to the plate, depending on the steel grade and plate processing history. The strength increase is due to work hardening whereas any decrease in strength arises from...

Improvement of die life in the hot forging of brass alloys is considered vital from both technical and economical points of view. In this research, pin-ondisc tests were carried out at a range of temperatures to evaluate the influence of plasma nitriding and duplex nitriding-physical vapour deposition (PVD), including TiN-TiAlN and TiN-TiAlN-CrAlN coatings, on the tribological properties of AIS...

Steel is the material of choice for a large number and very diverse industrial applications. Surface qualities along with other properties are the most important quality parameters, particularly for flat-rolled steel products. Traditional manual surface inspection procedures are awfully inadequate to ensure guaranteed quality-free surface. To ensure stringent requirements of customers, automate...

In this work, AISI 4340 steel was produced by powder metallurgy. Samples were sintered at 1150?C for 90 min. and then cooled in the furnace. Except to those as-sintered condition, one of samples homogenized 1 h air. Other deformed temperature range 1150-930?C deformation rate 30 60% followed cooling sand, air water mediums. The grain size gradually decreased depending on or steel. Small grains ...

Welding hot-work tool steels, containing 0.3-0.6% of carbon, is difficult both because of the elevated carbon content and because of significant hardening resulted from large amounts of alloying elements. A development of welding technology, i.e. better quality of electrodes, modern welding devices, improved welding technologies and better steel quality, make welding of such steel types possibl...

In the flat products steel industry, the hot rolling mill transforms the incoming slabs in a thin coil which then can be processed to obtain the final products. Thickness is reduced by pulling the plate between two parallel rolls while moving the upper work roll. The effect of uneven thickness at both sides can produce deviations in the longitudinal direction of the slab, which have to be manua...