The National Renewable Energy Laboratory presented an investigation of various wind turbine drivetrain condition monitoring (CM) techniques at the 7 International Workshop on Structural Health Monitoring held in 2009. The study contained in this report is a continuation of the 2009 paper and focuses on results obtained by various CM techniques from a damaged Gearbox Reliability Collaborative te...

A permanent magnet synchronous generator (PMSG) variable speed wind turbine connected to an electrolyzer and a battery model system is presented in this paper. Hydrogen gas could be produced from the model system, when a variable wind speed is applied to the PMSG driven variable wind turbine. The simulation results presented shows the nature of some of the variables of the PMSG wind driven turb...

There is a strong incentive for gas turbine operators to minimize and control performance degradation, as this directly affects profitability. The area of gas turbine recoverable and non-recoverable performance degradation will be comprehensively treated in this tutorial. Deterioration mechanisms including compressor and turbine fouling, erosion, increased clearances, and seal distress will be ...

A thermodynamic process of power generation has been developed for a gas turbine, a steam turbine, and a compressor, supported by adiabatic expansion or compression processes. Recently, the possible inlet temperature of gas turbines has been increased to 1500°C or more, and the inlet temperature of steam turbines also has been increased to 650°C. At these high-temperature conditions, turbine no...

Aggressive fuel burn and carbon dioxide emission reduction goals for future gas turbine engines will require higher overall pressure ratio, and a significant increase in turbine inlet temperature. These goals can be achieved by increasing temperature capability of turbine engine hot section materials and decreasing weight of fan section of the engine. NASA is currently developing several advanc...

The effect of a regenerative heat exchanger in a gas turbine is analyzed using a regenerative Brayton cycle model, where all fluid friction losses in the compressor is quantified by an isentropic efficiency term and all global irreversibilities in the heat exchanger are taken into account by means of an effective efficiency. This analysis, which generalizes that reported by Gordon and Huleihil ...

Regarding the increased energy consumption of the processes at the operational units in the National Iranian Oil Company, the present study analyzed energy consumption at one of the gas refineries. In this refinery, which is the main supplier of Fajr Jam refinery for the national gas network, as well as an injection into the oil fields of the Iranian South oil company, the pressure of gas after...

In cooperation with Rolls-Royce and Lund University, a combined cycle power plant was modelled, simulated and optimised in the new software framework, the GTPOM tool, developed through the recent EC FP5 programme. The goal was not only to calibrate its component models but also to show how this new tool can be used. This paper presents the gas turbine and combined cycle whole plant modelling an...

flow in the first two-stage of v 94.2 gas turbine is simulated numerically. in this turbine, the second stator is clocked relative to the first stator to different positions. steady-state analysis was carried out by varying the circumferential relative position of the consecutive stator vanes to study the effects of the clocking on turbine performance. a density based compressible inviscid flow...

Aiming at the problems existing in fault diagnosis of Distributed micro gas turbine, a kind of new information system frame of fault Diagnosis on Distributed micro gas turbine is proposed in this paper. The consumers and the manufactures contact with each other through Internet, share the corresponding data of the Distributed Micro-turbine, and diagnose and solve the faults together. Through th...