In this experimental work, Manganese oxide (MnO2), Zinc oxide (ZnO), Iron oxide (Fe2O3) and Magnesium chloride (MgCl2) were used as activating flux to investigate the effects for SS 304 in tungsten inert gas (TIG) welding. Ultimate tensile strength, percentage elongation, Penetration depth and width were studied of material SS 304. The experimental results indicated that the MnO2 and Fe2O3 flux...

Percentage error (relative to the observed value) is often felt to be more meaningful than the absolute error in isolation. The mean absolute percentage error (MAPE) is widely used in forecasting as a basis of comparison, and regression models can be fitted which minimize this criterion. Unfortunately, no formula exists for the coefficients, and models for a given data set may not be unique. We...

The dynamics of fast gas heating in a high power microwave discharge in air, is investigated in the framework of FDTD simulations of the Maxwell equations coupled with the fluid simulations of the plasma. It is shown that, an ultra-fast gas heating of the order of several 100 Kelvins occurs in less than 100 ns. The main role in the heating is played by the electron impact dissociation of , diss...

Relations between expiratory reserve volume (ERV), closing volume (CV) as a percentage of vital capacity (CV/VC%), and pulmonary gas exchange have been investigated in the sitting and supine postures in eight severely obese subjects before and after substantial weight loss. CV/VC% exceeded predicted values but did not change with posture or weight loss; the increase could have been owing to the...

Dimensional distortion occurs due to the thermal and transformation stresses formed during the heat treatment processes. Taguchi and Factorial design of experiment concepts were applied to optimize the operating variables involved in the gas carburising and induction hardening processes so as to minimize the geometrical distortions. Experimental data obtained for the materials EN353, EN351, AIS...

A design point simulation and adaptation of anindustrial GE LM2500+ gas turbine engine is presented. The design point is chosen when the engine runs steadily at operating point and close to the nominal design condition at 29MW power output. The targeted performance parameters are the fuel flow rate (FF), the compressor exit total pressure (P3), the compressor turbine total exit temperature (T8)...

Background: The quantitative contribution of cardiopulmonary bypass (CPB) to respiratory dysfunction after cardiac surgery is not documented and the effect of the use of bilateral internal mammary artery (IMA) grafts is not clear. Methods: One hundred and seventy-®ve patients undergoing CABG with (CPB, n ˆ 150) and without (NOCPB, n ˆ 25) CPB were studied. PMN elastase (as a marker of the syste...

Four in vitro experiments (Exp.) were conducted to evaluate lavender essential oil (LEO) effects at 0 (control), 250 (low dose), 500 (medium dose), 750 and 1000 µL per L (high doses) of incubation medium on rumen gas production kinetics (Exp.1), ruminal digestibility and fermentation (Exp.2), methane production (Exp.3) and rumen acidosis (Exp.4). The asymptote of gas production (A) increased qu...

Accurate and timely glucose monitoring is essential in intensive care units. Real-time continuous glucose monitoring system (CGMS) has been advocated for many years to improve glycemic management in critically ill patients. In order to determine the effect of calibration time on the accuracy of CGMS, real-time subcutaneous CGMS was used in 18 critically ill patients. CGMS sensor was calibrated ...