We reported a type-I difference-frequency generator (DFG), based on erbium doped GaSe (Er:GaSe) crystals as a coherent infrared source tunable from 2.4 mum to 28 mum. The two mixing beams used for the DFG are a tunable near infrared output (1.1-1.8 mum) from an optical parametric amplifier (OPA) and the fundamental beam of a picosecond Nd:YAG laser at 1.064 mum. The system can produce a maximum...

The two-cord retraction technique is used for troughing around a crown to achieve biologic width. This technique can cause significant discomfort for the patient and offers several potential clinical disadvantages for the dentist, of which unpredictable tissue recession is the most significant. The clinical case presented in this article compares the use of the standard two-cord retraction tech...

The noise spectrum of the unlocked Erbium-doped laser offset.

Erbium-doped Y20 3 planar optical waveguides have been fabricated by spray-pyrolysis deposition. The attenuation spectrum of the waveguide shows peaks that are due to absorption of the erbium ions. The as-deposited layers also show photoluminescence sharply peaking at 1540 nm with additional Stark splitting. The thin layers of Er 3:Y 203 obtained are promising for the realization of integrated-...

Laser operation at 2.8 microm in BaY(2)F(8) with erbium concentrations of 7.5% and 20% is investigated under laser-diode pumping at 967 nm. Output powers as high as 250 mW and slope efficiencies as high as 24% are obtained. Results are comparable with those of Er(3+):LiYF(4) under the same pump conditions. Slope efficiencies above 30% are predicted for optimized erbium concentrations.

We demonstrate a high-repetition-rate soliton fiber laser that is based on highly doped anomalously dispersive erbium-doped fiber. By splicing an 11 mm single-mode fiber to the erbium-doped fiber, the thermal damage of the butt-coupled saturable Bragg reflector (SBR) is overcome. The laser generates 187 fs pulses at a repetition rate of 967 MHz with a measured long-term stability of more than 6...

The activation energy for the surface self-diffusion of epitaxial erbium crystals grown on a tungsten field emitter tip has been examined. It was found to be strongly dependent both on the crystallographic orientation of the tip and the direction of electric field applied. The values of the activation energy, calculated from Arrhenius-type plots, and also field emission patterns of epitaxial Er...

PURPOSE THE AIM OF THIS STUDY WAS TO DETERMINE THE EFFICIENCY OF ERBIUM, CHROMIUM: Yttrium-Scandium-Gallium-Garnet laser in different output powers for removing permanent resin cement residues and therefore its influence on microshear bond strength compared to other cleaning methods. MATERIALS AND METHODS 90 extracted human molars were sectioned in 1 mm thickness. Resin cement was applied to ...