Magnesium is used implant material potentially for non-toxicity to the human body. Due to the excellent bio-compatibility, Mg alloys is applied to implants avoiding removal second surgery. However, it is found commercial magnesium alloys including aluminum has low corrosion resistance, resulting subcutaneous gas bubbles and consequently the approach as permanent bio-materials. Generally, Alumin...

Thin anodic porous alumina (tAPA) was fabricated from a 500 nm thick aluminum (Al) layer coated on silicon wafers, through single-step anodization performed in a Teflon electrochemical cell in 0.4 M aqueous phosphoric acid at 110 V. Post-fabrication etching in the same acid allowed obtaining tAPA surfaces with ≈160 nm pore diameter and ≈80 nm corresponding wall thickness to be prepared. The tAP...

The use of aluminum alloys as a material for engineering components that rub against each other is increasing, so it important to know the friction characteristics these alloys. In this study, Aluminum 2024 was given heat treatment with variation in aging time and anodization. Then, wear coefficient tests were carried out using pin tool on disc. effect surface anodization are determine amount t...

Porous aluminum oxide membranes with a complete and even covering of alumina nanowires were formed in a one-step anodization process in dilute phosphoric acid electrolyte. The anodizing conditions can be adjusted to start forming alumina wires that originate on the surface of the porous alumina layer at the triple junction points (the edges of the hexagonal inter-pore structure where three pore...

Highly ordered nanoporous anodic aluminum oxide (AAO) thin films were fabricated in oxalic acid under a constant voltage via a two-step anodization process. To investigate the high-aspect-ratio (7.5:1) filling process, both sputtering and atomic layer deposition (ALD) were used to form TiO2 nanowires. Field emission scanning electron microscopy and high-resolution transmission electron microsco...

Our research was aimed at the study of aluminum films and porous anodic alumina (PAA) films in thin-film РАА/Al structures for optical sensors, based on metal-clad waveguides (MCWG). The results of the scanning electron microscopy (SEM) and atomic force microscopy (AFM) studies of the structure of Al films, deposited by DC magnetron sputtering, and of PAA films, formed on them, are presented in...

– A theory of the spontaneous formation of spatially regular hexagonal arrays of nanopores in aluminum oxide film growing during aluminum anodization is presented. Linear stability analysis shows that, in certain ranges of the applied voltage and electrolyte pH, the oxide film is unstable with respect to perturbations with a well-defined wavelength. The instability is caused by a positive feedb...

Highly ordered silicon (Si) nanopores with a tunable sub-100 nm diameter were fabricated by a CF4 plasma etching process using an anodic aluminum oxide (AAO) membrane as an etching mask. To enhance the conformal contact of the AAO membrane mask to the underlying Si substrate, poly(methyl methacrylate) (PMMA) was spin-coated on top of the Si substrate prior to the transfer of the AAO membrane. T...