The objective of the study was to evaluate the degree of temperature change in the bone, directly adjacent to the implant site during the abutment part of one-piece implants, during procedures involving different cutting techniques. Three different one-piece implants: Osteoplant, Nobel Direct, Q-implant were cut with air-turbine burs after insertion in fresh pig ribs. Tests were performed with ...

This paper describes a comparison of tool life between ceramics and cubic boron nitride (CBN) cutting tools when machining hardened steels using the Taguchi method. An orthogonal design, signal-to-noise ratio (S/N) and analysis of variance (ANOVA) were employed to determine the effective cutting parameters on the tool life. The results indicated that the V was found to be a dominant factor on t...

High-speed machining (HSM) has emerged as a key technology in rapid tooling and manufacturing applications. Compared with traditional machining, the cutting speed, feed rate has been great progress, and the cutting mechanism is not the same. HSM with coated carbide cutting tools used in high-speed, high temperature situations and cutting more efficient and provided a lower surface roughness. Ho...

In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...

Xylem resistance to water stress-induced cavitation is an important trait that is associated with drought tolerance of plants. The level of xylem cavitation experienced by a plant is often assessed as the percentage loss in conductivity (PLC) at different water potentials. Such measurements are constructed with samples that are excised underwater at native tensions. However, a recent study conc...

It is well known that the linear extension majority (LEM) relation of a poset of size n ≥ 9 can contain cycles. In this paper we are interested in obtaining minimum cutting levels αm such that the crisp relation obtained from the mutual rank probability relation by setting to 0 its elements smaller than or equal to αm, and to 1 its other elements, is free from cycles of length m. In a first par...

This paper presents an investigation of the mechanism of the brittle–ductile cutting mode transition from the perspective of the mechanics. A mechanistic model is proposed to analyze the relationship between undeformed chip thickness, deformation, and stress levels in the elastic stage of the periodic chip formation process, regarding whether brittle or ductile mode deformation is to follow the...

The different player positions in rugby union may place varying demands on a reconstructed anterior cruciate ligament (ACL) in regards to 'cutting manoeuvres', this in turn may effect performance. In order to investigate sporting performance post reconstruction, a questionnaire was sent to amateur rugby clubs affiliated to the Oxfordshire Rugby Football Union (R.F.U). From the returned question...

Machining operations of aluminum structural parts are typically carried out under high feeds and high cutting speeds. These cutting conditions exert thermal and mechanical loads on the workpiece, which cause changes in the subsurface material. Residual stresses belong to the machining induced changes and can lead to considerable rejection rates as a consequence of part distortion. Due to the si...