Mortars containing carbon, polyethylene, and stainless steel fibers at the same volume fraction and with similar fiber diameters were compared in terms of tensile, compressive, and flexural properties. Carbon fibers, though having the lowest tensile modulus, stren[?th, and elongation at break among the fiber types, [?ave mortar of the highest tensile strenf?th and lowest cost; polyethylene fibe...

in this paper the traditional covering plaster of masonry buildings is supplied with polypropylene and steel fiber to enhance their seismic behavior. the plaster mix proportion is determined by some initial mortar tests. also, one story, single span masonry building specimen plastered with different mortars is tested on a shaking table 8 times under a seismic input and the performance of the sp...

In this paper, the compressive behavior of fiber-reinforced concrete with end-hooked steel fibers has been investigated through a uniaxial compression test in which the variables were concrete compressive strength, fiber volumetric ratio, and fiber aspect ratio (length to diameter). In order to minimize the effect of specimen size on fiber distribution, 48 cylinder specimens 150 mm in diameter ...

This study evaluates the fracture properties and rear-face strain distribution of nonreinforced and hooked steel fiber-reinforced concrete panels penetrated by projectiles of three different nose shapes: sharp, hemispherical, and flat. The sharp projectile nose resulted in a deeper penetration because of the concentration of the impact force. Conversely, the flat projectile nose resulted in sha...

Abstract: A new reinforced SFRFLC (abbr. steel fiber reinforced full-lightweight concrete) superposed beam was proposed to sufficiently utilize the good peculiarities of ordinary concrete in compression and SFRFLC in tension, and reduce its self-weight. Experimental study was carried out on the flexural behaviors of reinforced SFRFLC superposed beams compared with reinforced concrete beams and ...

The use of thulium fiber laser (TFL) as a potential alternative laser lithotripter to the clinical holmium:YAG laser is being studied. The TFL's Gaussian spatial beam profile provides efficient coupling of higher laser power into smaller core fibers without proximal fiber tip degradation. Smaller fiber diameters are more desirable, because they free up space in the single working channel of the...

Introduction Tendons and ligaments are composed of highly aligned collagen fibers that, at the micron-scale, have an intrinsically crimped micro-architecture. With stretch, crimped fibers straighten, resulting in a non-linear mechanical response. Crimp is thus a critical structural adaptation providing function under physiologic strain and is lost with pathological conditions. When such tissues...

A systematic morphological investigation of human palmaris longus tendons by polarisation microscopy and low angle x-ray diffraction is reported. It is shown that contrary to some previously reported observations, and in common with other tension bearing soft collagenous tissues, the fibres in this tendon are crimped. A new method of preparation of the tissue enabling one to see directly the cr...

This report presents the results of an experimental study that was conducted to investigate the effects of key parameters on the compressive behavior of fiber reinforced polymer (FRP)concrete-steel double-skin tubular columns (FSDT). Hybrid FSDT columns have been introduced as a new form of hybrid columns. They consist of an outer tube made of FRP and inner tube made of steel, with sandwiched c...

The ceramic fiber business of Shinnikka Thermal Ceramics Corporation began in March 1984 when its Sakai Works (then Nippon Steel Chemical Sakai Works) started production of ceramic fibers after several years of preparatory arrangements. The continuous reheating furnace having all-ceramic fiber lining, high thermal efficiency and low thermal inertia that was adopted for the plate mill (put into ...