This paper proposes a single stage solar power generation with boost dc-ac inverter by simple control technique. The boost dc-ac inverter converts and boosts a low output dc voltage of the solar pv array into a 220Vrms ac voltage at a fundamental frequency of 50Hz in single stage. A simple Modified Non-Linear State Variable Structure (MNLSVS) closed loop control technique is proposed to keep th...

A new zero voltage switching (ZVS) dc / dc converter operating on constant frequency and having wide linearity is proposed. ZVS operations are achieved not only for the primary switches but also for the secondary rectifier diodes to reduce the switching stresses and losses. The proposed converter also overcomes the other shortcomings of the conventional resonant dc / dc converters such as high ...

Objective Preferably (in general) electronic circuitry is energized from a voltage source, i.e., a source for which ideally no current flows under open-circuit conditions. Absent the need to maintain the load current stand-by power dissipation will be minimal. In addition a DC (unipolar constant voltage) power supply virtually always is preferable over an AC supply for electronic equipment. An ...

Abslrad : Some practical methods --r implementing the sliding-mode control law to control the buck-type converters are introduced. The control equations are derived from the basic slidmg-mode control law to accommodate the conventional fiied-frequency pwm control method. As a result, the overall feedback control systems can be expressed under a form similar to state-feedback control where the v...

A non-isolated DC/DC converter with high transfer gain is proposed in this paper. The presented converter consists of the switched inductor and three-level converters. The DC/DC power converter is three-level boost converter to convert the output voltage of the DC source into two voltage sources. The main advantages of DC/DC converter are using low voltage semiconductors and high gain voltage. ...

Voltage sags originating in ac supply systems can cause nuisance tripping of variable speed drives (VSDs) resulting in production loss and restarting delays. In ac VSDs having an uncontrolled rectifier front-end, the effects of voltage sags on the dc link causing dc under-voltage or ac overcurrent faults initiate the tripping. This paper suggests modifications in the control algorithm in order ...

In this paper presents new topologies Multilevel DC-DC buck-boost converter which consists of an inductor based boost circuit and a switched capacitor circuit has high voltage gain and flexible output voltage. Operation of these switching devices causes inherently nonlinear characteristic to the DC-DC Converters include buck-boost converter. It is suitable for a low voltage power source such as...

It is normally assumed that the dc-link is a perfect constant dc voltage. However. in a practical system. it contains ripple components due to the rectification process. An analysis of the power conversion process shows that the power at the dclink consists of constant active power as well as a pulsating component that fluctuates at twice the mains frequency. When a VSI is powered by the fluctu...

Due to the severity of the global energy crisis and environmental pollution, the photovoltaic (PV) system has become one kind of important renewable energy source. Solar energy has the advantages of maximum reserve, inexhaustibleness, and is free from geographical restrictions, thus making PV technology a popular research topic. This study is aimed at developing a PV charging system for Li-ion ...

This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are  red...