Duplex stainless steels (DSSS) have a microstructure composed of ferrite and austenite phases that gives them a very good combination of mechanical and corrosion properties. These steels are desirable for many applications in the chemical and petrochemical industries. In the present study, a type of stainless steel was cast, solution annealed at 1200°C for 60 min and then quenched in water. Ini...

The properties of the outer crust of non-accreting cold neutron stars are studied by using modern nuclear data and theoretical mass tables updating in particular the classic work of Baym, Pethick and Sutherland. Experimental data from the atomic mass table from Audi, Wapstra, and Thibault of 2003 is used and a thorough comparison of many modern theoretical nuclear models, relativistic and non-r...

the objectives in the cold rolling process include improved sheet surface quality, enhanced steel mechanical strength, and better solidification operations. given the increasing demand for higher steel surface quality, more rapid production, and thinner steel plates, more attention has been directed toward the parameter of temperature in cold rolling as a means of achieving the above objectives...

Nano/submicron austenitic stainless steels have attracted increasing attention over the past few years due to fine structural control for tailoring engineering properties. At the nano/submicron grain scales, grain boundary strengthening can be significant, while ductility remains attractive. To achieve a nano/ submicron grain size, metastable austenitic stainless steels are heavily cold-worked,...

It is likely that cold molecular clouds form at high redshift, before galaxies. Considering these cold clouds instead of hot homogeneous gas as the main baryonic component of proto-galactic halos may affect several issues during galaxy formation. In particular, the baryonic matter loses angular momentum through dynamical friction on the dark matter halo. In numerical simulations using hot gas f...

The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...