Five non-precious Ni-Co based alloys were analyzed with respect to their corrosion behaviour. The correlation between the amount of the elements Cr, Mo, V and the corrosion behaviour, expressed by the PREN (pitting resistance equivalent number) index in the case of the allied steels, was extended for Ni-Cr and Co-Cr dental alloys characterization. Open circuit potential, corrosion current densi...

Heat effects for the addition of Co in bulk and nanosized forms into the liquid Sn-3.8Ag-0.7Cu alloy were studied using drop calorimetry at four temperatures between 673 and 1173 K. Significant differences in the heat effects between nano and bulk Co additions were observed. The considerably more exothermic values of the measured enthalpy for nano Co additions are connected with the loss of the...

Two widely used jewellery investment casting alloys (platinum with 5 wt% ruthenium (Pt-5Ru) and platinum with 5 wt% cobalt (Pt-5Co)) suffer from poor castability and other drawbacks. In this work thermodynamic calculations of alloy properties were employed to optimise the alloy compositions. Segregation behaviour appeared to be important for the melting range. Scheil simulations were used to si...

NO reduction by CO was investigated over a AuPd(1 0 0) model catalyst at near atmospheric pressures. The alloy catalyst exhibits higher CO2 formation rates below 550 K than does pure Pd, although the binding energy of NO on the alloy surface is substantially less, i.e., its dissociation tendency is much less, compared with pure Pd. This behavior is rationalized by the fact that the low CO/NO-bi...

Bending property of Ti-Ni alloy dental castings was evaluated in comparison with that of Co-Cr alloy in a cantilever test. Heat treatment effect on the bending property was also investigated in relation to phase transformation. Ti-50.85Ni (mol%) alloy was used, and the shape of bending test specimens was half-rounded in cross section, 2.0mm in diameter. The bending test was carried out at 310K....

Single-walled carbon nanotubes (SWNTs) were synthesized using size-controlled catalyst nanoparticles created by the pulsed laser ablation method. Specifically, the alloy particles (Co/Mo or Co/Pt) were prepared by ablation of the target alloy materials in an inert gas atmosphere. Size selection was performed using a differential mobility analyzer (DMA). The obtained nanoparticles were deposited...