We present a detailed investigation of the surface characteristics of five commercial titanium implants with different surface finishing (double acid etching, anodization and incorporation of Ca/P, acid etching and deposition of Ca/P, hydroxyapatite-blasting, acid etching and Ca/P-blasting) produced by five different manufacturers. A set of experimental techniques were employed to study the sur...

Exposure to respirable crystalline silica is a hazard common to many industries in Alberta but particularly so in abrasive blasting. Alberta occupational health and safety legislation requires the consideration of silica substitutes when conducting abrasive blasting, where reasonably practicable. In this study, exposure to crystalline silica during abrasive blasting was evaluated when both sili...

Z. Kaláb, M. Stolárik, Institute of Geonics, Academy of Sciences, Czech Republic, B. Pandula, J. Kondela, Technical University of Košice, Institute of Geosciences, Slovakia The article summarizes experimental seismological measurements of vibration eff ects of blasting operations. During tunnel excavation can watch a variety of eff ects on the near or distant surroundings of the building. One o...

The impact of blast-driven shocks on the safety and stability of the underground coal mines has been well established. The seismic imperfections resulting from blasting depend on the total explosive energy released during blasting and the closeness of the development tunnel face to the stope face. Also, the quality of the rock mass wherein the whole stope face is located might pose considerable...

(1) Background: The assessment of airborne particulate matter (PM) and ultrafine particles (UFPs) in battlefield scenarios is a topic of particular concern; (2) Methods: Size distribution, concentration, and chemical composition of UFPs during operative military training activities (target drone launches, ammunition blasting, and inert bomb impact) were investigated using an electric low-pressu...

This study evaluated the effect of microrobotized blasting of titanium endosteal implants relative to their manually blasted counterparts. Two different implant systems were utilized presenting two different implant surfaces. Control surfaces (Manual) were fabricated by manually grit blasting the implant surfaces while experimental surfaces (Microblasted) were fabricated through a microrobotize...

The purpose of this study was to characterize the etching mechanism, namely, the etching rate and the activation energy, of a titanium dental implant in concentrated acid and to construct the relation between the activation energy and the nanoscale surface topographies. A commercially-pure titanium (CP Ti) and Ti-6Al-4V ELI surface were tested by shot blasting (pressure, grain size, blasting di...

Specimens (such as metal inlays) with 30 degrees or 45 degrees marginal bevel were prepared by casting with a 12% Au-Pd-Ag alloy or a gold alloy. A form of the marginal bevel was traced on a profile projector before and after sandblasting, and the length of the abraded margin measured. All the blasting conditions abraded the marginal bevel, while the blasting at 20 mm for 2 seconds brought abou...

The assessment of fragmentation through blasting and therefore subsequent crushing and grinding stages is important in order to control and optimize the mining operation. Prediction of the mean size of fragmented rock by the rock mass characteristics, the blasting geometry, the technical parameters and the explosive properties is an important challenge for the blasting engineers. Some of the ef...

Interactive theorem proving requires a lot of human guidance. Proving a property involves (1) figuring out why it holds, then (2) coaxing the theorem prover into believing it. Both steps can take a long time. We explain how to use GL, a framework for proving finite ACL2 theorems with BDDor SAT-based reasoning. This approach makes it unnecessary to deeply understand why a property is true, and a...