Automotive steels with ultra-high strength and low alloy content under different heating cooling processes were investigated. It was shown that those exhibited a great influence on the performance of investigated due to auto-tempering effects. Compared water quenching, there approximately 70% increase in elongation air cooling, which martensite well-tempered. Although steel microstructure compo...

The microstructure and properties of a 5 wt.% Cr cold work tool steel were studied after austenitisation at 1020°C, 1050°C or 1075°C followed by single, double and triple tempering treatments at 525°C. The microstructures were investigated with scanning electron microscopy and X-ray diffraction and phase transformations were studied by dilatometry. Furthermore, hardness and Charpy un-notched an...

Natural fibers are emerging as low cost, lightweight and apparently environmentally superior alternatives to glass fibers in composites. We review select comparative life cycle assessment studies of natural fiber and glass fiber composites, and identify key drivers of their relative environmental performance. Natural fiber composites are likely to be environmentally superior to glass fiber comp...

We introduce a new update scheme to systematically improve the efficiency of parallel tempering Monte Carlo simulations by taking into account the temperature dependence of autocorrelation times. In contrast to previous attempts the temperatures are not dynamically adjusted but chosen in such a way that the acceptance rate for proposed exchanges of all adjacent replica is about 50%. We show tha...

Introduction: With the extensive application of radiation sources and radioactive materials in various fields, the study of attenuation and absorption of X-rays and gamma-rays in several materials has become an essential and interesting field of research. Glass materials are possible alternatives of concretes for radiation-shielding materials.   Materials and Methods:...

We give conditions under which a Markov chain constructed via parallel or simulated tempering is guaranteed to be rapidly mixing, which are applicable to a wide range of multimodal distributions arising in Bayesian statistical inference and statistical mechanics. We provide lower bounds on the spectral gaps of parallel and simulated tempering. These bounds imply a single set of sufficient condi...

The present paper explores a simple approach to the question of parallel tempering temperature selection. We argue that to optimize the performance of parallel tempering it is reasonable to require that the increase in entropy between successive temperatures be uniform over the entire ensemble. An estimate of the system's heat capacity, obtained either from experiment, a preliminary simulation,...

to investigate the effect of tempering treatment on mechanical properties and the microstructure ofdin 1.4021 martensitic stainless steel, austenite treatment was conducted for the samples at 1000ºc temperature for 60 min and then the samples were oil quenched. later, tempering treatments wereperformed for the samples at 500 ºc and 700 ºc temperatures for 2 and 5 h, respectively; then quenching...

This investigation is concerned to evaluate the influence of heat treatment on mechanical behavior of AISI1040 steel; it is one of the grades of medium carbon steel of American standard containing 0.40% carbon in its composition. Specimen of quenched/hardened AISI1040 steel was tempered at temperature (650,450&250°C) for 60, 90&120 minutes to modify desired properties. The mechanical behavior, ...