Molten salts are widely used to extract oxides and particulate phases from molten Al and protect Al from oxidization during molten aluminum alloys processing. It was reported that TiCN showed a reasonable stability in molten aluminum during solidification nanoprocessing of aluminum matrix nanocomposites. To further verify the TiCN stability in molten aluminum in molten salt, EDX and TEM were us...

A modified strain-induced melting activation (SIMA) process is shown to improve high-temperature formability. The microstructural characteristics of the spheroidized grains of SIMA-processed alloys affect high-temperature formability. The effects of hot extrusion parameters and chemical composition on the evolution of spheroidized grains were investigated using several 6xxx series aluminum allo...

Fe-Al intermetallic alloys with aluminum content over 60 at% are in the area of the phase equilibrium diagram that is considerably less investigated in comparison to the high-symmetry Fe₃Al and FeAl phases. Ambiguous crystallographic information and incoherent data referring to the phase equilibrium diagrams placed in a high-aluminum range have caused confusions and misinformation. Nowadays une...

Low frequency internal friction measurements have been made on "pure" aluminum and dilute aluminum alloys in heavily cold-worked states. A relaxation peak is observed at about 200 K(for 1Hz) even in specimens of nominally 4N or higher purity. This peak is considered to be the same as those previously reported by several researchers for dilute aluminum alloys of Cu, Mg or Ga. Among various eleme...

Development of an accurate neuronal material model for aluminum alloys would facilitate better process control and parameter optimization in the aircraft industry. This research primarily attempts to design a connectionist constitutive model for aluminum 7075 alloy using multi-layer perceptrons. The backpropagation algorithm is used to train the designed network whose performance is then valida...

HEDRICK, H. G. (General Dynamics/Fort Worth, Fort Worth, Tex.), C. E. MILLER, J. E. HALKIAS, AND J. F. HILDEBRAND. Selection of a microbiological corrosion system for studying effects on structural aluminum alloys. Appl. Microbiol. 12:197200. 1964.Two laboratory methods, a metal-strip test and a tank test, were evaluated as microbiological corrosion systems for producing corroded test specimens...

The benefits of energy and operational cost savings from using copper rotors are well recognized. The main barrier to die casting copper rotors is short mold life. This paper introduces a new approach for manufacturing copperbar rotors. Either copper, aluminum, or their alloys can be used for the end rings. Both solid-core and laminated-core rotors were built. High quality joints of aluminum to...

Until 2000 almost all research in the microwave sintering area was confined to non-metallic materials. However, after the first report by Penn State in 1999 on full sintering of steel powders in microwave, now in the last few years there has been increasing interest in applying microwave energy for processing of variety of metallic materials. The present study is an extension of this work and r...