نتایج جستجو برای: 3d numerical model
تعداد نتایج: 2466060 فیلتر نتایج به سال:
run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...
Numerical simulation of the deformation process during flat rolling of multifilament HTS tapes has been investigated using a commercial FEM program, ELFEN. The numerical models were built up in 2D and 3D using a DruckerPragerKap model for the powder. Three different roll diameters (024 mm, 0 8 5 mm and 0126 mm) have been investigated. It is found that it is possible to perform numerical simulat...
Local scouring around bridge piers is a natural phenomenon caused by the erosive process of flowing stream on alluvial beds. The 3D flow field around bridge piers interacting with the bed materials increases complexity of local scour process. The local scour depth develops in accelerated flows and if it is not predicted correctly, the bottom level of local scour hole will exceed the original le...
This study aims to numerically investigate on the crashworthiness of thin-walled square tubes by consideration of 3-D oblique loading. In this type of loading, direction of loading is defined by using two spatial angles relative to the position of the tube. To this aim, finite element (FE) analysis is employed to simulate the loading for 8 different numerical models with different loading orien...
Aseismic safety of dam involves people’s lives and properties, even has a great impact on national economic development. The key to this project is to have a fairly complete fluid-structure interaction (FSI) theory and a calculation method with a good accuracy. Therefore, focused on the FSI dynamic problem of gravity dam under seismic action, this paper presented the non-linear 2.5D dynamic the...
This article describes a 3D CFD (computational fluid dynamics) simulation implementation of the stepped planning hull in calm water. The turbulent free surface flow around the stepped planing hull is computed with a RANSE method, using the solver ANSYS-CFX. The turbulence model used is standard k–ε. In order to simulate the disturbed free surface, VOF model is implemented. The CFD model has bee...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید