In rock drilling, bit wear is a major factor in determining bit life, the cost of drilling and may significantly influence the drilling method selected for given rock type. Effective control of bit wear can yield significant cost savings. Prediction of cuttability or drillability requires an understanding of the cutting action and the mode of wear and their interaction with the rock propertiesW...

Damage to mechanical components caused by wear is considered to be an important issue for mechanical engineers. For the purpose of wear resistance, it is necessary to improve the material properties of the mechanical elements. Furthermore, low friction plays an important role in saving energy. Hence, it is important to establish a key technology for wear resistance and low friction through appr...

tan films with different n2 partial pressure were deposited on 304 stainless steel using the magnetron sputtering method. the effect of gas pressure on the mechanical property, morphology and phase structure of the films is investigated by x-ray diffraction (xrd), atomic force microscopy (afm), microhardness testing, friction coefficient measurements, and wear mechanism study. the xrd results c...

  There are many factors such as voltages, duty cycle, pressure, temperatures and gas flux in coatings process that were effective in changing coatings characteristic. In this paper in plasma enhanced chemical vapor deposition (PECVD) technique, temperature and gas flux are two important variants that affecting the coatings structure and mechanical properties. All TiC coating deposited on a hot...

The average life span of knee prosthesis used in Total Knee Replacement (TKR) is approximately 10 to 15 years. Literature indicates that the reasons for implant failures include wear, infection, instability, and stiffness. However, the majority of failures are due to wear and tear of the prosthesis. The most common biopolymer used in TKR  is Ultra High Molecular Weight Polyethylene (UHMWPE). Pr...

The field of biomedical materials plays an imperative requisite and a critical role in manufacturing a variety of biological artificial replacements in a modern world. Recently, titanium (Ti) materials are being used as biomaterials because of their superior corrosion resistance and tremendous specific strength, freeallergic problems and the greatest biocompatibility compared to other competing...

Friction and wear are major limiting factors for the development and commercial implementation of devices fabricated by surface micromachining techniques. These tribological properties are studied using a polycrystalline silicon nanotractor device, which provides abundant, quantitative information about friction and wear at an actual microelectromechanical system (MEMS) interface. This in situ ...

Single and multipass two-body and three-body abrasive wear behaviour of various polyaryletherketone composites have been carried out by using a pin-on-disc machine and a rubber wheel abrasion test (RWAT) rig. Abrasive wear studies were conducted under different loads and sliding distances. Comparative wear performance of all the composites at different loads shows that specific wear rate (Ko) o...

|III Abstract Powder metallurgy (PM) is usually used in manufacturing parts with complex geometries, such as gears and structural parts. The main attractions of PM are the high rate of material utilization, environmental friendliness of production, economic advantages (especially for complex geometries), and possibility of obtaining lighter components. To find a wide range of applications and c...

Artificially fabricated surface textures can significantly improve the friction and wear resistance of a tribological contact. Recently, this surface texturing technique has been applied to polymer materials to improve their tribological performance. However, the wear behavior of textured tribo-pairs made of steel and polymer materials has been less thoroughly investigated and is not well under...