This paper presents an optimal design for a new humidity sensor composed of a dual-resonator oscillator configuration with an operation frequency of 300 MHz, and a polyaniline (PANI) coating deposited along the resonation cavity of the sensing device. To improve the corrosion resistance of the sensor chip, Al/Au electrodes were used to form the SAW resonator. Prior to device fabrication, the co...

Multimodal tactile sensing could potentially enable robots to improve their performance at manipulation tasks by rapidly discriminating between task-relevant objects. Data-driven approaches to this tactile perception problem show promise, but there is a dearth of suitable training data. In this two-page paper, we present a portable handheld device for the efficient acquisition of multimodal tac...

The advent of nanocrystalline metal oxide semiconductor permits microheater to be incorporated into integrated gas sensors to heat the sensing layer to a low temperature. The low temperature sensing allows the use of a relatively thin silicon membrane instead of zero Silicon membrane resulting into temperature uniformity across the entire active area (2mmx2mm) which in turn reduces the reliabil...

A bone reaming system with temperature tactile sensation display was developed for potential use during bone internal fixation surgery. The developed reaming system will allow tracking of the amount of heat generated inside fractured bones by surgeons throughout the reaming process. It consists of a temperature sensing system to measure the bone cavity temperature, a rotor system to provide the...

This paper reports a micromachined chemical sensor intended for harsh environments such as those near hydrothermal vents at the sea floor. The sensor is intended to measure the pH, dissolved H2 and H2S, and temperature. The device is 12 mm in diameter and 6 mm in effective length, including packaging. A YSZ|HgO|Hg solid electrode is used as a common electrode for measurement of the three chemic...

A fiber optical inclinometer based on modal interferometer is demonstrated for bend angle sensing. The device consists of a piece of simplified hollow core photonic crystal fiber sandwiched between single mode fibers with lateral offset. The measurement of bend angles up to 45° is demonstrated, and the spectrum exhibits a blueshift of over 50 nm. The sensitivity is found to increase with the ap...

This paper reports a novel coaxial cable Fabry-Perot interferometer for sensing applications. The sensor is fabricated by drilling two holes half-way into a coaxial cable. The device physics was described. The temperature and strain responses of the sensor were tested. The measurement error was calculated and analyzed.

we investigate the temperature-dependences of the Brillouin frequency shift in three different kind of single-mode fibers using a heterodyne method for sensing temperature. Positive dependences coefficients of 0.77, 0.56 and 1.45MHz/0C are demonstrated for 25 km long single-mode fiber, 10 km long non-zero dispersion shifted fiber and 100 m photonic crystal fiber, respectively. The results indic...