Oxides in steel weld metals can initiate fracture or can improve toughness by influencing the development of beneficial microstructures. In this work, the authors conducted experiments in which the oxygen concentration was varied from 20 to 560 ppmw (parts per million by weight) in weld metals with tensile strength in the range 580–780 MPa. It is demonstrated that low and medium strength weld m...

Tensile strength, Young's modulus, and toughness of electrospun nylon 6 non-woven fiber mats were improved by increasing individual nanofiber strength and fiber-fiber load sharing. Single-walled carbon nanotubes (CNTs) were used as reinforcement to increase the strength of the electrospun nylon 6 nanofibers. Young's modulus, tensile strength, and toughness of the nylon 6 non-woven fiber mats el...

Cracked and un-cracked Brazilian disc specimens subjected to diametral compression were used for conducting fracture toughness and tensile strength experiments on a polymer concrete (PC) material. The value of mode I fracture toughness (KIc) was determined from the center- cracked Brazilian disc and the indirect tensile strength (σt) was obtained from the un-cracked Brazilian disc specimen. The...

The aim of this study was to investigate the flexural behavior of engineered cementitious composites (ECCs) reinforced by cellulose pulp (CP) and cellulose microfibers (CMF). The reinforcements were obtained from chemical-mechanical treatments of Kraft paper and used in ECC mix design. Results showed that cement reinforced by CP exhibited a strain-hardening behavior in the three-point bending t...

Article history: Received 29.05.2012. Received in revised form 27.07.2012 Accepted 03.09.2012. The influence of sub-temperature quenching temperature on the tensile strength, hardness and toughness of 60Si2Mn steel has been studied, and the ferrite content, austenite grain size and martensite morphology of the microstructure of this steel after sub-temperature quenching analyzed. The results sh...

In this study, an industrial polycrystalline SiC tile was successfully sintered by pressureless sintering at 2150°C for 1 hour. The physical and mechanical properties of silicon carbide including density, hardness, bending strength, and fracture toughness were evaluated. The results indicated that the mentioned properties were 3.08 g.cm-3, 2503 HV0, 249.3 MPa, and 1.23 MPam0.5</...

The aim of the present work was to study the effect of various process parameters i.e. current, voltage, travel speed, electrode diameter, flux composition, pre heating of workpiece, electrode stick-out and edge including angle on changes in tensile strength and toughness of the weld bead geometry of HSLA Steel and to optimize the process so that minimal changes occur in the material properties...

In this paper, an ultra low carbon High Strength Low Alloy Grade Steel was subjected to a two-step forging process and this was followed by different post cooling methods. The highest strength was obtained at a faster cooling rate due to the highly dislocated acicular ferrite structure with the fine precipitation of microalloying carbides and carbonitrides. At a slow cooling rate, the strength ...

cracked and un-cracked brazilian disc specimens subjected to diametral compression were used for conducting fracture toughness and tensile strength experiments on a polymer concrete (pc) material. the value of mode i fracture toughness (kic) was determined from the center- cracked brazilian disc and the indirect tensile strength (σt) was obtained from the un-cracked brazilian disc specimen. the...

Nacre, the iridescent material in seashells, is one of many natural materials employing hierarchical structures to achieve high strength and toughness from relatively weak constituents. Incorporating these structures into composites is appealing as conventional engineering materials often sacrifice strength to improve toughness. Researchers hypothesize that nacre's toughness originates within i...