Solid lubricants used in aerospace applications must provide low friction and a predictable operation life over an extreme range of temperatures, environments and contact conditions. PTFE and PTFE composites have shown favorable tribological performance as solid lubricants. This study evaluates the effect of temperature on the friction coefficient of neat PTFE, a PTFE/ PEEK composite and an exp...

Tribological coatings made of MoS2 and WSe2 phases and their corresponding combinations with tungsten carbide (WC) were prepared by non-reactive magnetron sputtering of individual targets of similar composition. A comparative tribological analysis of these multiphase coatings was done in both ambient air (30-40% relative humidity, RH) and dry nitrogen (RH<7%) environments using the same tribome...

A composite coating of polytetrafluoroethylene and epoxy shows 100 · improvements in wear resistance as compared to either of its constituents alone and reduced friction coefficient under testing on a pin-on-disk tribometer. This coating is made by impregnating an expanded PTFE film with epoxy, which provides three unique functions: (1) the epoxy compartmentalizes the PTFE nodes, which is belie...

The melting of ultrathin lubricant film by friction between atomically flat surfaces is studied. The additive noises of the elastic shear stress and strain, and the temperature are introduced for building a phase diagram with the domains of sliding, stick-slip, and dry friction. It is shown that increase of the strain noise intensity causes the lubricant film melting even at low temperatures of...

Recently, there has been much interest in using lubricated surfaces to achieve extreme liquid repellency: a foreign droplet immiscible with the underlying lubricant layer was shown to slide o at a small tilt angle<5. This behaviour was hypothesized to arise from a thin lubricant overlayer film sandwiched between the droplet and solid substrate, but this has not been observed experimentally. Her...

Within the framework of Lorentz model for description of viscoelastic medium the influence of deformational defect of the shear modulus is studied on melting of ultrathin lubricant film confined between the atomically flat solid surfaces. The possibility of jump-like and continuous melting is shown. Three modes of lubricant behavior are found, which correspond to the zero shear stress, the Hook...