Introduction. In addition to good biological properties, biomaterials should also possess appropriate physical properties in order provide stability and longevity at the place of application. The aim this work was evaluate an experimental nanostructured material based on calcium aluminate (CAL) silicate (CS). Material method. research used synthesized by hydrothermal solgel method from individu...

The phenomenon of evanescent-wave scattering (EWS) is used to design an optical-fiber humidity sensor. Porous solgel silica (PSGS) coated on the surface of a silica optical-fiber core scatters evanescent waves that penetrate the coating layer. Water molecules in the gas phase surrounding the optical fiber can be absorbed into the inner surface of the pores of the porous silica. The absorbed wat...

In this study, calcium phosphate nanoparticles with two phases, fluorapatite (FA; Ca(10)(PO(4))(6)F(2)) and hydroxyapatite (HA; Ca(10)(PO(4))(6)(OH)(2)), were prepared using the solgel method. Ethyl phosphate, hydrated calcium nitrate, and ammonium fluoride were used, respectively, as P, Ca, and F precursors with a Ca:P ratio of 1:72. Powders obtained from the sol-gel process were studied after...

Magnetic powder of Sr-ferrite was prepared by conventional and sol-gel auto-combustion methods. In conventional method, strontium carbonate and ferric oxide powders were mixed together and then mixture was calcined. In sol-gel auto-combustion method, a solution containing strontium nitrate, ferric nitrate and citric acid was heated until the combustion took place automatically; then, as-burnt p...

In previous studies nano sized hydroxyapatite (HA) particles were prepared by solgel or precipitation methods, in which the products were washed by aqueous or non-aqueous liquids to remove impurities or undesired components. The washing is know to modify the surfaces of the cystalline particles. This study evaluated properties of nano HA materials prepared by a spray drying method in which the ...

We report the results of an experimental study to determine influence pressure on diffusion creep in wet olivine. In order observe at high-pressure conditions laboratory strain rates, we prepared ultra-fine grained (0.22–0.72 μm) olivine aggregates both from San Carlos and oxide mixtures using a solgel technique. All samples contain some water (~1000 ppm wt) presumably due adsorption fine-grain...

Electrorheological (ER) properties under oscillatory shear of perchloric acid doped-poly(3-thiopheneacetic acid)/oil (P3TAA/silicone) suspensions have been investigated. The effects of electric field strength, silicone oil viscosity, and particle concentration were investigated. When the electric field strength reaches a critical value, the P3TAA-based ER fluid exhibits transitional behavior be...

High quality manganese oxide thin films with smooth surfaces and even thicknesses have been prepared with a nonaqueous sol-gel process involving reduction of tetraethylammonium permanganate in methanol. Spin-coated films have been cast onto soft glass, quartz, and Ni foil substrates, with two coats being applied for optimum crystallization. The addition of alkali metal cations as dopants result...

Copper (Cu) ions are of interest with respect to materials for bone regeneration because of their pro-angiogenic potential. One of the problems with synthetic bone scaffolds is the fast decrease in viability of cells with increasing distance from the surface of the scaffold material, which results from the inability of nutrients and oxygen to diffuse further than 150-200 μm from the surface wit...

We demonstrate that isophthalic acid-ended telechelic poly(1,5-cyclooctadiene)s (APCODs) form thermo-reversible gels in non-polar solvent with a unique molecular mechanism for their thermo-reversibility. Like other associative telechelic polymers, A-PCODs form “flower-like” micelles at low concentration and form gels through bridging at higher concentration which exhibit linear viscoelasticity....