The microstructure of multiphase steels assisted by transformation-induced plasticity consists of grains of retained austenite embedded in a ferrite-based matrix. Upon mechanical loading, retained austenite may transform into martensite, as a result of which plastic deformations are induced in the surrounding phases, i.e., the ferrite-based matrix and the untransformed austenite. In the present...

Although high carbon martensitic steels are well known for their industrial utility in high abrasion and extreme operating environments, due to their hardness and strength, the compressive stability of their retained austenite, and the implications for the steels' performance and potential uses, is not well understood. This article describes the first investigation at both the macro and nano sc...

This paper traces the historical development of the methods, techniques, and applications related to the measurement of retained austenite by x-ray diffraction from the early 1930s to the present.

The stress-induced transformation behavior of retained austenite is considered in this work. With the development of transformationinduced plasticity (TRIP) steels this deformation mode is of growing importance. Twinned martensite structures were calculated using the crystallographic theory of martensite. An available work criterion was used to predict the transformation potentials for 16 diffe...

Low-temperature bainite, obtained by the transformation of austenite at temperatures as low as 200oC for times as large as several days, has been reported to have extraordinary mechanical properties including the highest reported hardness of any bainitic steel. The unusual properties are a consequence of the fine scale of the microstructure, which contains bainite plates with thickness in the r...

The stabilization of retained austenite was studied via a two-step cooling procedure. Alloys with M , temperatures below 0 OC were used. It was found that the martensitic transformation starting temperature, M,, was lowered to M,' during the second step of cooling. With increasing the amount of previously formed martensite, the difference in the transformation starting temperatures, AM, (= M,M,...

to investigate the effect of tempering treatment on mechanical properties and the microstructure ofdin 1.4021 martensitic stainless steel, austenite treatment was conducted for the samples at 1000ºc temperature for 60 min and then the samples were oil quenched. later, tempering treatments wereperformed for the samples at 500 ºc and 700 ºc temperatures for 2 and 5 h, respectively; then quenching...