the use of twb has been developed in automotive industries because of it’s advantages such as reduction in weight, cost and fuel economy of vehicles. the main objective of the peresent work is to study the effects of weld zone, diffrence in surface coating and thickness ratio on the formability of twb composed of aisi 304, spcc and if steel sheets. it was found that the narrow weld zone has lit...

TWIP-cored three-layer steel sheets were newly fabricated by hot rolling of TWIP steel sheet surrounded by low-carbon (LC) or interstitial-free (IF) steel sheets. TWIP/LC or TWIP/IF interfaces were well bonded without pores or voids, while a few pearlites were thinly formed along the interfaces. The strengths and elongation of the TWIP-cored sheets increased as the volume fraction of TWIP-cored...

In order to investigate the structure of Fe–Zn phase in a commercial galvannealed IF steel sheet, the electron diffraction and composition of phase in a commercial galvannealed IF steel sheet were studied by transmission electron microscope (TEM) and X-ray energy dispersive spectroscopy (EDX). The cross-sectional TEM specimen was prepared using focused ion beam (FIB) technique which was also in...

In the present paper the corrosion properties of structured sheet metals were investigated. The aim of this work is to determinate the influence of the structuring process on the corrosion resistance of sheet metals. For this purpose, these sheets were examined by accelerated tests in corrosion chamber. The investigation was carried out using salt spray test. The experiment was conducted for th...

The effect of additions of antimony (0.05% Sb) to silicon steel on the improvement of the electrical properties of non-oriented steel sheet was investigated. Measurements of surface segregation of Sb were performed under UHV conditions in the temperature range from 450 to 900 OC, using AES and TDS. Maximum equilibrium surface segregation of antimony was determined at 700 OC. At higher temperatu...

In this case study we discuss a simple control system used for obtaining a desirable downstream surface temperature inside a hot rolling steel sheet, presented by Bao Steel in the HK Study Group with Industry, held at the City University of Hong Kong, July 2002.

Forming limit curves (FLC) of deep drawing steel sheets have been determined experimentally and calculated on the base of the material tensile properties following the Hill, Swift, Marciniak-Kuczyński and Sing-Rao methods. Only the FLC modeled from a singly linear forming limit stress curve exhibits good consistence with experimental curve. It was established that a linearized limit stress locu...

The automotive industry is using more and more of Advanced High Strength Steel in order to reduce the weight of the car. Since this will generate more springback, it is of vital importance to be able to predict the amount of springback in the parts. Otherwise, many late changes have to be made in order to fit the parts in their position. In order to increase the ability to understand and test t...

the effect of steel plate thickness on the repair effectiveness of rc beam is presented in this paper. a total of four beams were tested, one beam repaired by cfrp with a thickness of 1.2 mm and used as a control beam, and three beams repaired by a steel plate. steel plates with a thickness of 2 mm, 3 mm, and 4 mm were used in repairing the beams. the maximum load-carrying capacity, deflection ...