S. Rešković, I. Jandrlić, University of Zagreb, Faculty of Metallurgy, Sisak, Croatia, F. Vodopivec Institute of Metals and Technology, Ljubljana, Slovenia Using thermal imaging camera during tensile testing of low carbon and Nb microalloyed steel influence of testing rate on start of plastic deformation was investigated. The results showed that the onset of plastic flow is significantly differ...

Detailed activation, decay heat and waste disposal calculations of the ARIES-AT design are performed to evaluate the safety aspects of the device. The high initial activity of the SiC highly irradiated components translates directly into a higher initial decay heat for these structures than for the well-protected steel-based components. However, after a one-hour cool-down period, the SiC decay ...

A program has been conducted on the effects of Mg in cast alloy 718. The results show that small amounts of Mg improves impact toughness and decreases Nb segregation by decreasing secondary dendrite arm spacing which results in less and smaller interdendritic Laves and MC eutectics. Small amounts of Mg produce a more spheroidal as well as a more dispersive MC phase. Impact toughness was found t...

The paper demonstrates the potential of wet ball milling metals for synthesis various carbides and carbohydrides. work reports on multicomponent formed in Ti-(Cu/Fe/Si)-C, W-Fe-C, Nb-(Cu/Fe/Si/Al)-C systems, as well metastable or high-temperature intermetallics Ti-Si, Nb-Si, Nb-Al, Nb-Cu-Fe which are stabilized with interstitial carbon. formation phase composition powders fabricated under mecha...

A comprehensive set of models of precipitate formation during steel processing has been developed. In this work, it is applied to investigate Nb(C,N) precipitation in thin microalloyed steel slabs during continuous casting, reheating in a tunnel furnace and water quenching relative to the position with the slab and alloy content. The models include a transient heat-conduction and solidification...

The causes of liquation cracking in the heat-affected zone (HAZ) of a cast Mar-M004 superalloy weld were investigated. X-ray diffraction (XRD), electron probe microanalyzer (EPMA), and electron backscatter diffraction (EBSD) were applied to identify the final microconstituents at the solidification boundaries of the cast alloy. Fine borides and lamellar eutectics were present in front of some γ...

Large diameter steel line pipes are generally produced by cold deforming hot rolled or thermomechanically controlled rolled (TMCR) plate by the three-stage 'UOE' process. Pipe strength has been found to increase or decrease relative to the plate, depending on the steel grade and plate processing history. The strength increase is due to work hardening whereas any decrease in strength arises from...

The behavior of the slag layer between the oscillating mold wall, the slag rim, the slag/liquid steel interface, and the solidifying steel shell, is of immense importance for the surface quality of continuous-cast steel. A computational model of the meniscus region has been developed, that includes transient heat transfer, multi-phase fluid flow, solidification of the slag, and movement of the ...

In this study, we have investigated the microstructure and mechanical properties of two refractory high entropy alloys (RHEAs), Ti-V-Cr5-Nb-Ta Ti-V-Cr-Nb-Ta, in their as-cast heat-treated conditions. Both show almost single-phase BCC structure, while different size volume fraction secondary phases were formed after homogenisation heat treatment. The major phase was indexed as a complex C15 Lave...