introduction: evaluation of bonding in atomic level, by sem/eds analysis of si atoms, is an exact method for determination of bond strength of metal and porcelain. the purpose of this study was to evaluate the bond strength of one noble alloy and two base metal alloys with and without beryllium. methods and materials: six specimens of each alloy begostar, rexillium iii, wiron 99 (10×10×1mm dime...

Results of initial investigation of thermomechanical couplings in innovative β-Ti alloy called Gum Metal subjected to tension are presented. The experimental set-up, consisting of testing machine and infrared camera, enabled to obtain stress-strain curves with high accuracy and correlate them to estimated temperature changes of the specimen during the deformation process. Both ultra-low elastic...

Ten dental casting alloys were tested for alloy-element release into cell-culture medium, and this release was related to alloy composition, alloy microstructure, and alloy cytotoxicity (previously determined). Cell-culture medium was analyzed for alloy elements by flame atomic absorption. Concentrations of elements in the medium were normalized by dividing them by their atomic abundance in the...

Background: The purpose of this study was to compare and evaluate the effects of metal primer on the shear bond strength of denture base resin to base metal alloy after electrolytic and laser etching. Materials and Methods: A total of 48 cobalt‐chromium (Co‐Cr) alloy specimens were fabricated. The specimens were divided into 6 groups of 8 specimens each. Group I: Sandblasting (control group). G...

GaInSn, a eutectic alloy, has been successfully used in the Magneto-Thermofluid Research Laboratory at the University of California-Los Angeles and at the Princeton Plasma Physics Laboratory for the past six years. This paper describes the handling and safety of GaInSn based on the experience gained in these institutions, augmented by observations from other researchers in the liquid metal expe...

In the present study, the microstructure and mechanical properties of the dissimilar welding between ASTM A335 low alloy steel and ER309L austenitic stainless steel were investigated using the gas tungsten arc welding process. The welding of dissimilar materials between ASTM A335 low alloy steel and ER309L austenitic stainless steel was found to have a significant effect on the microstructure w...

This short review describes various types of anti-corrosion additives of water-soluble metal working fluids for aluminum alloy materials. It is concerned with synthetic additives classified according to their functional groups; silicone compounds, carboxylic acids and dibasic acids, esters, Diels-Alder adducts, various polymers, nitrogen compounds, phosphoric esters, phosphonic acids, and other...

In the present study, an attempt has been made to investigate the influence of the forging parameters on cutting forces for different cutting speed, depth of cut, and feed rate during machining of Al 7075 alloy and Al 7075 alloy with short basalt fiber reinforced metal matrix composites. The experiments were conducted by using a lathe machine with tool dynamometer setup. KeywordForging effect, ...