The inrush current is a transient current that results from a sudden change in the exciting voltage across a transformer’s windings. It may cause inadvertent operation of the protective relay system and necessitate strengthening of the transformer’s mechanical structure. Many methods were reported in the literatures for reduction and mitigation of transformer inrush currents. This paper represe...

This paper presents the application of the fuzzy-neuro method toinvestigate transformer inrush current. Recently, the frequency environment ofpower systems has been made more complicated and the magnitude of the secondharmonic in inrush current has been decreased because of the improvement of caststeel. Therefore, traditional approaches will likely mal-operate in the case ofmagnetizing inrush w...

Abstract—The proposed Thysristor based soft starter using will be simulating in PSCAD on a three-phase induction generator for limitation of Massive inrush current which is 34 times more than the generator current & cause Massive Mechanical stress on coupling, bearing gear & shaft of wind mill poly phase generator during connection with Grid. Experimental results shown a significant reduction i...

The energizing of large power transformers has long been considered a critical event in the operation of an electric power system. When a transformer is energized by the utility, a typical inrush current could be as high as ten times its rated current. This could cause many problems from mechanical stress on transformer windings to harmonics injection, and system protection malfunction. There h...

This paper proposes a new algorithm for blocking the operation of Indirect Symmetrical Phase Shift Transformer (ISPST) differential relay when subjected to different operating conditions except internal fault condition. The proposed algorithm is amalgamation of Phase angle shift (PAS) threshold and Optimal Radial Basis Function Neural Network (ORBFNN). PAS between source and load side currents ...

This paper describes the reduced capacity of the inrush current suppressor using a matrix converter (MC) in a large-capacity wind power generation system (WPGS) with two squirrel-cage induction machines (SCIMs). These SCIMs are switched over depending on the wind speed. The input side of the MC is connected to the source in parallel. The output side of the MC is connected in series with the SCI...

The behavior of three phase five leg transformer under voltage sag is studied in this paper. This paper proposes a simple, practical model of a three phase-five leg, saturated transformer with accurate performance. Transformer saturation is produced when the voltage sag is recovered and it causes inrush current in transformer. Effects of voltage sag depth, duration and initial point on wave hav...