We had recently measured a chromatic dispersion of optical fiber and a time delay of chirped fiber grating based on a bidirectional modulation of an optical intensity modulator. In this paper, we analyze characteristics of the chromatic dispersion measurement method using a bidirectional modulation of an optical intensity modulator, and give a detailed explanation about the selection of measure...

Abstract This paper presents a new method to obtain the deformation distribution on main reflector of an antenna only by measuring electric intensity spherical surface with focal point as center sphere, regardless phase. Combining differential geometry theory geometric optics method, this has derived deformation-intensity equation relate near-field directly. Based finite difference (FDM) and Ga...

conclusions in this study¸ rosa damascena and mefenamic acid had similar effects on pain intensity of primary dysmenorrhea . with further studies, rosa damascena which has no chemical side effects¸ can be suggested for treating primary dysmenorrhea. results there was a significant difference between the average of pain intensity at different hours of measurement in each group after the end of f...

In this work, we propose a multi-parametric sensor able to measure both temperature and radiation intensity, suitable to increase the level of integration and miniaturization in Lab-on-Chip applications. The device is based on amorphous silicon p-doped/intrinsic/n-doped thin film junction. The device is first characterized as radiation and temperature sensor independently. We found a maximum va...

MOTIVATION Labeling techniques are being used increasingly to estimate relative protein abundances in quantitative proteomic studies. These techniques require the accurate measurement of correspondingly labeled peptide peak intensities to produce high-quality estimates of differential expression ratios. In mass spectrometers with counting detectors, the measurement noise varies with intensity a...

In this paper, we demonstrate a fast binary intensity modulation based on the measurement of the binary TM. For each correction, the binary TM was calculated based on measurements of the intensity change at the target with a series of input masks. After preloading the measurement masks, the DMD can run at full speed during measurement. The system allows dynamic focusing at 12.5 Hz with 1024 inp...

introduction: application of light transmitting posts to restore greatly damaged endodontically treated teeth has been increased. it is suspected that light intensity decreases as it passes throughout different materials. this can reduce the degree of conversion required for adequate bond strength throughout the length of these posts. the objective of this study was to evaluate the amount of li...