Experimental investigations has been done to find out the heat transfer characteristics and friction factor of water based Al2O3 nanofluids as a coolant in  brazed plate heat exchanger. Plate heat exchanger either use horizontally or vertically. The base plate of the plate heat exchanger was kept inclined at (0⁰, 30⁰ ,60⁰, 90⁰). The experimentation have been done on the two different concentrat...

In this paper, a fuzzy model-based algorithm is developed for leak detection in a pilot heat exchanger. A dynamic fuzzy model is first derived from input-output measurements using a fuzzy clustering technique. This model is run in parallel to the process for residual generation. The detection scheme has been tested and validated using real data from a co-current heat exchanger, and has proven t...

Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...

"> Waste heat recovery is very important, because it not only reduces the expenditure of heat generation, but also it is of high...

The effect of pulsation on the heat transfer rates, for turbulent water stream with upstream pulsation of different amplitudes, in a double-pipe heat exchanger for both parallel and counter flows, with cold water on the shell side, was investigated. Pulsation frequencies, with using a reciprocating device, ranged up to 260 cycles per minute (up to 4.3 Hz) and 5 different displacement amplitudes...

Single staggered is a design development of normal wire and tube heat exchanger that wires are welded with staggered configuration on two sides. Capacity of wire and tube heat exchanger is the ability of the heat exchanger to release heat. The objective of this study is to analyse the effect of wire pitch (pw) on capacity of single staggered wire and tube heat exchanger. The research...

An investigation on enhancement of heat transfer is carried out for a double pipe exchanger in which the outer wall inner provided with circumferential labyrinth passages. Rectangular and triangular cavities fixed tooth thickness, height, pitch are considered effect added structures characteristics discussed. A two-dimensional steady numerical simulation using ANSYS-FLUENT software. The flow Re...

Common approaches to the simulation of Borehole Heat Exchangers (BHEs) assume heat transfer in circulating fluid and grout to be in a quasi-steady state and ignore fluctuations in fluid temperature due to transport of the fluid around the U-tube loop. Such effects have been shown to have an impact on peak temperatures and hence operation of heat pumps systems when short time scales are consider...