This paper is concerned with adaptive stabilization of open loop unstable fluidized bed spray granulation with internal product classification by means of nonlinear feedback control. Since the process model is represented by a nonlinear partial integro-differential equation, direct stabilization of the particle size distribution in a Lp or L∞ norm is difficult. To overcome this problem a stabil...

Effects of rapid heat transfer using a fluidized bed on the heat-treating response of Al-Si-Mg alloys (both unmodified and Sr modified) were investigated. The heating rate in the fluidized bed is greater than in conventional air convective furnaces. Particle size analyses of eutectic Si showed that the high heating rate during fluidized bed solution heat treatment causes faster fragmentation an...

Introduction Understanding the jetting phenomena near the gas distributor plate in a fluidized bed is important to gassolids mixing, heat and mass transfer, and erosion on any bed internals, which can all affect the performance of the bed. Moreover, acoustic vibration in a fluidized bed can be used to enhance the fluidization quality of particulate matter. Visualizing the jetting structure usin...

This paper is concerned with stabilizing open loop unstable fluidized bed spray granulation with internal product classification by means of low order control methods. The process under investigation can be described by a population balance equation. In order to design a low order controller numerical approximation and model reduction methods are applied resulting in a low order design model. S...

several methods are used to decrease seed drying time and enhance the quality of dried seeds. influidization methods, good aeration occurs during the drying process. in this research, conditioned seedswith 20% d.b. moisture content were dried at 30°, 40°, 50° and 60°c using three bed conditions (fixed,minimum fluidized, fluidized). all experiments were done using a batch-type fluidized bed drye...

Spirals as internals are utilized to reduce the axial mixing of solids in fluidized beds, by routing the solids flow in a predetermined route or by localizing the solids mixing. The drying kinetics of continuous fluidized bed with and without internals has been compared and modeled using batch drying kinetics and residence time distribution analysis. The batch drying experiments were conducted ...

Theoretical and experimental studies of the granulation process mineral fertilizers were considered in order to identify a mathematical model relationship between vibration noise spectrum installation fluidized bed distribution granule mass by diameter, as main indicator quality product. A method current (inertial-free) control diameter optimal time has been developed. The based on analysis all...

Chemical looping with oxygen uncoupling (CLOU) is an efficient process for solid fuel combustion CO2 capture. This requires a material that capable of releasing gaseous O2 within high temperature window. Screening was performed reactive CuO-based carriers prepared the CLOU magnetic properties easy separation from ashes. The effects CuO fraction, method preparation (with prior Fe-Mn support or b...

The hydrodynamic studies of fluidized bed reactor has been reported in terms of pressure drop, minimum fluidization velocity and bed volume expansion to contribute to the optimization of the CNTs production parameters in fluidized bed reactors. Minimum fluidization velocity and pressure drop, as the most important parameters, were taken into account for the investigation of the hydrodynamic beh...

−The information of particle cluster dynamics is necessary for improving the performance of a circulating fluidized bed system. The main objective of this study is to compare the particle cluster diameters and concentrations from computational fluid dynamics simulation results between circulating fluidized bed riser and downer. The calculation methodologies are based on the concept of kinetic t...