The noise spectrum of the unlocked Erbium-doped laser offset.

Erbium-doped Y20 3 planar optical waveguides have been fabricated by spray-pyrolysis deposition. The attenuation spectrum of the waveguide shows peaks that are due to absorption of the erbium ions. The as-deposited layers also show photoluminescence sharply peaking at 1540 nm with additional Stark splitting. The thin layers of Er 3:Y 203 obtained are promising for the realization of integrated-...

Laser operation at 2.8 microm in BaY(2)F(8) with erbium concentrations of 7.5% and 20% is investigated under laser-diode pumping at 967 nm. Output powers as high as 250 mW and slope efficiencies as high as 24% are obtained. Results are comparable with those of Er(3+):LiYF(4) under the same pump conditions. Slope efficiencies above 30% are predicted for optimized erbium concentrations.

We demonstrate a high-repetition-rate soliton fiber laser that is based on highly doped anomalously dispersive erbium-doped fiber. By splicing an 11 mm single-mode fiber to the erbium-doped fiber, the thermal damage of the butt-coupled saturable Bragg reflector (SBR) is overcome. The laser generates 187 fs pulses at a repetition rate of 967 MHz with a measured long-term stability of more than 6...

The activation energy for the surface self-diffusion of epitaxial erbium crystals grown on a tungsten field emitter tip has been examined. It was found to be strongly dependent both on the crystallographic orientation of the tip and the direction of electric field applied. The values of the activation energy, calculated from Arrhenius-type plots, and also field emission patterns of epitaxial Er...

PURPOSE THE AIM OF THIS STUDY WAS TO DETERMINE THE EFFICIENCY OF ERBIUM, CHROMIUM: Yttrium-Scandium-Gallium-Garnet laser in different output powers for removing permanent resin cement residues and therefore its influence on microshear bond strength compared to other cleaning methods. MATERIALS AND METHODS 90 extracted human molars were sectioned in 1 mm thickness. Resin cement was applied to ...

The aim of this study was to evaluate the efficacy of autologous platelet-rich plasma (PRP) combined with erbium fractional laser therapy for facial acne or acne scars. PRP combined with erbium fractional laser therapy was used for the treatment of 22 patients, including 16 patients who suffered from facial acne scars and 6 patients who suffered from acne scars concomitant with acne. Whole bloo...

The influence of energy-transfer upconversion (ETU) between neighboring ions in the upper and lower laser levels of erbium 3m continuous-wave lasers on heat generation and thermal lensing is investigated. It is shown that the multiphonon relaxations following each ETU process generate significant heat dissipation in the crystal. This undesired effect is an unavoidable consequence of the efficie...

Erbium (Er) ion has been widely used in silica fiber-based active photonic devices, given its characteristic emission around 1.5 μm. Hydrogenated and deuterated amorphous carbon (a-C:H and a-C:D, respectively), thin film materials offering tailorable opto-electronic properties, have not been explored thoroughly as host materials for Er. The objective of this research is to study the potential s...

We demonstrate a low-threshold microsphere laser on a silicon chip, fabricated from erbium-doped silica sol–gel film. Single-longitudinal mode lasing emission is observed from a 37 μm diameter microsphere cavity with an erbium ion concentration of 2× 1019 cm−3. The measured lasing threshold of the silica microsphere laser is as low as 4.8 μW. (Some figures may appear in colour only in the onlin...