In the present work, the interaction of Rayleigh waves with a delamination in a fiber reinforced composite plate was analyzed. Rayleigh waves, upon interacting with delamination mode, convert into Lamb waves in the delamination zone. These guided Lamb modes have the capability to mode convert back into Rayleigh modes when they interact with the edge of the delamination. A unidirectional glass/e...

Drilling-induced delamination often occurs both at the entrance and the exit of the workpiece during drilling of composite material. Investigators have studied analytically and experimentally that delamination in drilling can be correlated to the thrust force of the drill. With a pre-drilled pilot hole, the delamination can be reduced significantly. Early reference reported models of drilling-i...

A study was undertaken using electrochemical impedance spectroscopy to measure delamination and compare that measurement, which can be performed on the sample repeatedly, with the accepted method of cathodic disbondment (CD) testing, the major drawback of which is that this measurement can only be done once on the sample; in reaching this goal, EIS could be used to predict delamination based on...

The susceptibility of QFN package to delamination, particularly in the area between the Ni/Pd/Au leadframe die pad and mold compound, has been a major concern to many IC manufacturers. The presence of a Ni/Pd/Au oxide layer on the leadframe of QFN packages was found to cause delamination at the die pad or mold compound interface. Delamination refers to the disbonding between a surface of the mo...

in this research, b4c-ni cermet coating was sprayed on the surface of 4130 steel from b4c and ni feed-stockpowders using high velocity oxy-fuel (hvof) method. in order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 n.phase analysis of the coating after spraying was studied by x-ray diffracto...

Coordination of neural crest cell (NCC) induction and delamination is orchestrated by several transcription factors. Among these, Sry-related HMG box-9 (Sox9) and Snail2 have been implicated in both the induction of NCC identity and, together with phoshorylation, NCC delamination. How phosphorylation effects this function has not been clear. Here we show, in the developing chick neural tube, th...

It is difficult to detect delamination of rotating composite components like helicopter and wind turbine blades while in-service with a wired system. In the present study, a wireless system using a tiny oscillation circuit for detecting delamination of carbon/epoxy composites is proposed. In this system, a tiny oscillation circuit is attached to the composite component. When delamination of the...

Delamination is one of the most common failure modes in composite structures. In the case of in-plane compressional loading, delamination of a layered flat structure can cause a local buckling in delaminated area which subsequently affects the overall stiffness of the initial structure. This leads to an early failure of the overall structure. Moreover, with an increase in load, the delaminated ...

The buckling and postbuckling behaviors of a composite beam with single delamination are investigated. A three-dimensional finite element model using the commercial code ANSYS is employed for this purpose. The finite elements analyses have been performed using a linear buckling model based on the solution of the eigenvalues problem, and a non-linear one based on an incremental-iterative method....

Compressing a thin elastic film attached to a thick compliant substrate can lead to buckling instability. Two commonly observed buckling modes, buckle-delamination and wrinkling, have each been analyzed separately in previous studies. Recent experiments have observed that the two modes can co-exist and co-evolve. In this paper, by analytical and finite element methods, we present a study on con...