-This scheme presents an integrated solution for Photo Voltaic cell(PV) fed water-pump drive machine which uses an Open-End Winding Induction Motor (OEWIM). The dual inverter fed OEWIM drive achieves the functionality of a three level inverter and needs low value DC bus voltage. This helps in optimal arrangement of Photo voltaic cells, this can avoid large strings and helps in improving the PV ...

Here an improved three-level integrated ac–dc converter is presented. This converter improving or boosting power factor correction. And also this converter topology is advanced than previous ac-dc converters mainly the converter is operating with two independent controllers. An input controller is used to power factor correction and it regulates the dc bus, and the output controller is used to ...

Three-phase three-wire Distribution Static Compensator (DSTATCOM) with Photovoltaic (PV) array or battery operated DC-DC boost converter is proposed in this paper. The proposed DSTATCOM consists of a three-leg Voltage Source Converter (VSC) with a DC bus capacitor and it provides continuous reactive power compensation, source harmonic reduction and load compensation throughout the day. With the...

A single stage single switch AC/DC converter is an integration of input current shaper and a DC/DC cell with a shared controller and one active switch. The converter is applicable for digital input power supply with high input power factor and tight output voltage regulation. The focus of the topology is to reduce the DC bus voltage at light load without compromising with input power factor and...

This paper proposes a novel high-efficiency isolated three-port bidirectional DC/DC device for photovoltaic (PV) systems. The device contains a high step-up converter for PV modules to supply power to the DC bus, and a bidirectional charge/discharge control circuit for the battery with an improved boost-flyback converter. When the PV modules supply sufficient energy, their output can be stepped...

Modulation strategies for multilevel inverters have typically focused on synthesizing a desired set of three phase sinusoidal voltage waveforms using a fixed number of dc voltage levels. This results in the average current injection and hence the net power drawn from the multiple dc bus terminals to be unmatched and time varying. Subsequently, the dc-bus voltages are unregulated, requiring corr...

DC-BUS based power distribution systems with battery backup have been widely used in aerospace and telecommunication applications, where the bus voltage is usually determined by the battery. In these systems, there are many loads that need different and low operating voltages. Since the bus voltage is usually much higher than the load voltage and varies in a wide range with the stage of charge ...

This paper addresses voltage control of distributed dc power systems. DC power systems have been discussed as a result of the introduction of renewable, small-scale power generation units. Also, telecommunication power systems featuring UPS properties might benefit from a broader introduction of dc power systems. Droop control is utilized to distribute the load between the source converters. In...

The Space Vector Pulse Width Modulation (SVPWM) Technique has become one of the important PWM techniques for Three Phase Voltage Source Inverter (VSI) for the control of AC Induction Motors and Permanent magnet Synchronous Motors. The study of SVPWM technique reveals that space vector modulation technique utilizes DC bus voltage more efficiently and generates less harmonic distortion when compa...

<span>In DC microgrids, the utilization of renewable energy results in disruptions. This paper proposes coordinated control multiple batteries using a fuzzy logic controller (FLC). The goal is to regulate voltage and power on microgrid. Method used with modified coupling configuration. proposed new topology uses 2 photovoltaic (PV) arrays. Part PV array output will be stored battery, part...