We have investigated the contributions of CuO planes and CuO chains on the transport properties of YBa Cu O by 2 2 4 8 Ž . Ž . measuring the electrical resistivity and thermoelectric power S of Y Pr Ba Cu Zn O , Y Ca Ba Cu O and 1yx x 2 1yy y 4 8 1yx x 2 4 8 Ž . YBa Cu Ga O . Pr reduces the mobile carrier concentration in the CuO planes in YBa Cu O , as a consequence, the 2 1yx x 4 8 2 2 4 8 Ž ...

Large-scale Ni-doped ZnO nanowire (NW) arrays are grown. The electrical conductivity of a single Ni-doped ZnO NW has been increased for 30 times. The photoluminescence (PL) spectrum of the doped ZnO NWs has a red shift, suggesting possible doping induced band edge bending. The doped NW arrays could be the basis for building integrated nanoscale transistors, sensors, and photodetectors.

Metal-doped zinc oxide (ZnO) nanorod arrays have attracted much attention due to improvement in their electrical, structural, and optical properties upon doping. In this chapter, we discuss the effects of aluminum (Al)and iron (Fe)-doping on ZnO nanorod arrays properties particularly for humidity sensor applications. Compared to Fe, Al shows more promising characteristics as doping element for ...

Zinc oxide (ZnO, n-type) and copper oxide (CuO, p-type) nanowires have been synthesized and preliminarily investigated as innovative materials for the fabrication of a proof-of-concept thermoelectric device. The Seebeck coefficients, electrical conductivity and thermoelectric power factors (TPF) of both semiconductor materials have been determined independently using a custom experimental set-u...

in this paper, the photocatalytic degradation of lidocaine hcl, an anesthetic was investigated inaqueous solution using cuo/zno as a photocatalyst. the degradation was studied under differentconditions including the amount of the photocatalyst, irradiation time, initial concentration of drug,ph of the system, initial concentration, addition of oxidant on the reaction rate and anion presence.the...

Copper, zinc, and cerium oxide adsorbents supported on alumina were used to remove silane gas (SiH4). The adsorbents were prepared using a coprecipitation method and characterized by the inductively coupled plasma mass spectrometry, X-ray powder diffractometer, and Brunauer-Emmett-Teller method (BET). The silane removal efficiency and adsorption capacity of the adsorbents were investigated in t...

Even with rigorous environmental regulations, phenol still is a major contaminant. One possible solution is the use of heterogeneous photocatalysis due to low chemical addition, feasibility and reliability to be implanted on cost-effective industrial process. TiO2 is the most employed photocatalyst because of its favorable (photo) chemical properties and ZnO is considered one of the best altern...

ZnO-CuO mesocrystal was prepared via topotactic transformation using one-step direct annealing of aqueous precursor solution and assembled into a H2S sensor. The ZnO-CuO mesocrystal-based sensor possesses good linearity and high sensitivity in the low-concentration range (10-200 ppb). Compared to pure CuO, the as-prepared ZnO-CuO mesocrystal sensor exhibited superior H2S sensing performance wit...