Saponins, molecules classified as triterpenic or steroidal glycosides, are metabolites distributed in all the plant kingdom that can be used for the production of foods, cosmetics, and pharmaceuticals, as well as in soil bioremediation. Saponins are normally extracted from natural resources with water, ethanol and/or methanol, and then concentrated by liquid-liquid partitioning with n-butanol. ...

Most livestock and poultry odors are generated by the anaerobic decomposition of livestock wastes such as manure (feces and urine), spilled feed, bedding materials, and wash water. Increased organic loading rates due to expanding animal numbers, slug loading, concentrated waste streams, and/or inadequate amounts of dilution water increase the potential for odor emissions from waste management s...

This 3D finite element study assessed the stress distribution in mandibular overdenture supported by the 3i Locator system attached to two cylindrical or conical implants placed at the canine region. A 100 N vertical load was applied over the right first molar of the two overdenture models. The von Mises stresses were concentrated at the cervical and middle implant thirds. Cylindrical implants ...

An unsaturated polyester resin (UPR) mortar was applied to repair the damage tension zone's one-way reinforced concrete (RC) slabs. The load carrying capacity of patched RC slab is interest justify effectiveness repair. Yield Line Theory (YLT) may be used estimate slabs under concentrated load. results YLT are compared with experimental evaluate validity method. confirm that patching alters yie...

Distal extension removable partial denture (RPD) can cause stress on supporting hard tissues, which may lead to harmful effects. The purpose of this study is to investigate the pattern of these stresses over the residual alveolar ridge and alveolar bone around the abutment teeth by distal extension conical crown retained te lescop ic dentures (CCRTDs) with different taper angles using three dim...

Three-dimensional finite element models are developed to investigate the effects of both tensile load and uniform temperature load on the stresses in hybrid joints. During the solution of the problem, finite element method (FEM) is preferred, as this method is very suitable for solving many engineering problems. An aluminum sheet is bonded a composite sheet. Hybrid joints are designed from both...

PURPOSE Polymeric porous foams have been evaluated as possible new pharmaceutical dosage forms. METHODS These materials were obtained by polymerization in the continuous phase of highly concentrated emulsions prepared by the phase inversion temperature method. Their porosity, specific surface and surface topography were characterized, and the incorporation and release of active principles was...