The synthesis of bulk amounts of high quality single-walled carbon nanotubes (SWNTs) is accomplished by optimizing the chemical compositions and textural properties of the catalyst material used in the chemical vapor deposition (CVD) of methane. A series of catalysts are derived by systematically varying the catalytic metal compounds and support materials. The optimized catalysts consist of Fe/...

We study the maximum temperature rise induced by a rotating or dithering Gaussian laser beam on a semi-infinite body. An analytical solution is obtained by solving the transient three-dimensional heat equation in a semi-infinite domain with insulating surface. The effect of rotating or dithering frequency on maximum temperature rise is quantitatively investigated for stainless steel and carbon ...

We have investigated the electrochemical synthetic mechanism of conductive polymer nanotubes in a porous alumina template using poly(3,4-ethylenedioxythiophene) (PEDOT) as a model compound. As a function of monomer concentration and potential, electropolymerization leads either to solid nanowires or to hollow nanotubes, and it is the purpose of these investigations to uncover the detailed mecha...

In this study, titanium thin films were deposited on alumina substrates by radio frequency (RF) magnetron sputtering. The mechanical properties of the Ti coatings were evaluated in terms of adhesion strength at various RF powers, temperatures, and substrate bias voltages. The coating conditions of 400W of RF power, 250°C, and a 75V substrate bias voltage produced the strongest coating adhesion,...

Here we present an optofluidic surface enhanced Raman spectroscopy (SERS) device for on-chip detection of vasopressin using an aptamer based binding assay. To create the SERS-active substrate, densely packed, 200 nm diameter, metal nanotube arrays were fabricated using an anodized alumina nanoporous membrane as a template for shadow evaporation. We explore the use of both single layer Au struct...

We describe a fabrication strategy for preparing yttria-stabilized zirconia nanotube (YSZ-NT) arrays embedded in porous alumina membranes by means of template-directed atomic layer deposition (ALD) technique. The individual YSZ-NTs have a high aspect-ratio of well over 120, about ~ 110 nm in diameter, and ~ 14 µm in length. Interfacing the tube arrays with porous Pt was also introduced on the b...

We report that nanoparticulate zirconia (ZrO(2)) catalyzes both growth of single-wall and multiwall carbon nanotubes (CNTs) by thermal chemical vapor deposition (CVD) and graphitization of solid amorphous carbon. We observe that silica-, silicon nitride-, and alumina-supported zirconia on silicon nucleates single- and multiwall carbon nanotubes upon exposure to hydrocarbons at moderate temperat...

The single-walled carbon nanotube (SWCNT)-molecularly imprinted powder (MIP) composites in this paper were prepared by mixing SWCNTs with MIPs. The structure and micrograph of the as-prepared SWCNTs-MIPs samples were characterized by XRD and TEM. The gas-sensing properties were tested through indirect-heating sensors based on SWCNT-MIP composites fabricating on an alumina tube with Au electrode...

Nowadays, forward osmosis (FO) with many advantages in water treatment, are so attractive for researchers and investigators that the studies are going to optimize and increase its efficiency. However one of the most controversial operating malfunctions of FO process is fouling that limits the FO global application. In the following research, vertically aligned carbon nanotube (VACNT) on alumina...