Mesoporous Ni–alumina catalysts (Ni–alumina-pre and Ni–alumina-post) were synthesized by one-step sol–gel method using micelle complex comprising lauric acid and nickel ion as a template with metal source and using aluminum sec-butoxide as an aluminum source. The Ni–alumina catalysts showed relatively high surface areas (303 m/g for Ni–alumina-pre and 331 m/g for Ni–alumina-post) and narrow por...

PURPOSE The purpose of the present study was to evaluate the flexural strength of the joint between glass-infiltrated alumina frames and the experimental adjusting agent (MA modifier) that contains alumina and magnesia. METHODS A commercially available adjusting agent (Optimizer), a slurry of alumina powder (Alumina modifier), and a bulk specimen (joint-free alumina) were used as controls. Be...

in the present investigation surface modification of silica nanoparticles by alumina was carried out by sol-gel process. fourier transform infrared (ftir) and x-ray fluorescence (xrf) confirmed the synthesis of silica and the surface modification as alumina is anchored to silica surface. field emission scanning electron microscopy (fesem) and transmission electron microscopy (tem) investigation...

Porous alumina films had been fabricated by anodizing from aluminum films after an electropolishing procedure. Alumina stripes without pores can be distinguished on the surface of the porous alumina films. The width of the alumina stripes increases proportionally with the anodizing voltage. And the pores tend to be initiated close to the alumina stripes. These phenomena can be ascribed to the e...

Zirconia ultrafiltration membranes are widely developed and used for past several years. But the conventional sol-gel methods of zirconia membrane preparation involve many steps. In the present study an attempt was made to develop defect free zirconia ultrafiltration (UF) membrane in single step coating of zirconia nanopowder suspension by slip casting method over multichannel ceramic support. ...

Alumina is one of the most widely used adsorbent for removal of dissolved pollutants from waste water. Various chemical species, especially ions, are known to be adsorbed onto alumina. On the other hand, alumina is a typical support for catalysts. Many kinds of metal supported catalysts are prepared using alumina as their support. These two roles of alumina, i.e., as adsorbent and support, are ...

Alumina nanofibers were prepared by a technique that combined the sol-gel and electrospinning methods. The solution to be electrospun was prepared by mixing aluminum isopropoxide (AIP) in ethanol, which was then refluxed in the presence of an acid catalyst and polyvinylpyrolidone (PVP) in ethanol. The characterization results showed that alumina nanofibers with diameters in the range of 102 to ...

The control of particle size distribution of fabricated alumina nanoparticles from general alumina that has a large geometric standard deviation (GSD) is studied. A thermophoretic separator was used to control the GSD of the fabricated alumina nanoparticles. Unevaporated particles and primary particles were separated to yield a small GSD for fabricated alumina nanoparticles. The fabricated alum...

Though press and sinter powder metallurgy (PM) steel offers cost-effective solutions for structural applications, there is a constant drive improvement in their density. Addition of nanopowder to the conventional micrometre-sized metal explored improve In this study, effect addition varying amounts has been studied. Carbonyl iron (<5 ?m) water atomized (<45 were used as base which (<100 nm) was...